论文部分内容阅读
1.概述摩擦式提升机调绳车槽是一项重要的工作,这是因为,有的提升机在调绳中出现因绳力过紧而被拉断,造成平衡锤坠井的重大事故;有的提升机在车削绳槽时因进刀过猛,而挖去部分衬垫;有的在车削过程中掰断车刀刀头,甚至使固定刀架的钢梁拉翻;有的因过于频繁车削,而减少了衬垫的寿命;有的因管理欠佳,由于调绳车槽,而使检修时间拖延过长影响生产。为吸取各矿山教训,从1985年起,我矿主井推广应用网络计划,使调绳车槽工作保证了安全和工期。但是,因工序多,尤其是在绳多时进刀计算工作量太大,所以,每次检修用时都在14～16h左右。为了缩短检修时间,我们将计算机应用于调绳车槽,收到了良好的
1. Overview Friction hoist rope hoist slot is an important task, this is because some hoist rope in the rope tension due to being pulled off, causing the balance hammer to fall a major accident; Some hoist in the process of cutting the rope groove too much because of the feed, and dug part of the liner; some in the turning process to break the knife head, and even the fixed turret beam turned over; some because of too much Frequent turning, reducing the life of the liner; and some due to poor management, due to the tune the car slot, leaving the overhauling time delay affect the production. In order to draw lessons from various mines, since 1985, mine mine shaft to promote the use of network planning, so that the work of adjusting rope slot to ensure safety and construction period. However, due to the number of processes, especially when the rope is too much time to calculate the amount of work is too large, so each time overhaul are about 14 ~ 16h. In order to shorten the overhaul time, we applied the computer to the tuyere slot and received good