我厂是生产7.5千瓦以下直流电机的专业厂。电机定转子所用的硅钢片落料是由冲床单机冲制的。多年来,由于没有理想的取料机械手,不但影响了生产,而且很不安全,也曾发生过人身事故。为此我们先后试制了几种取料机械手(简称扒料器),经不断地改进,已基本定型,安装在内江锻压机床厂生产的80吨开式双柱可倾压力机(J23-80)上使用,效果较理想。最早的一台扒料器已使用一年多,累计工作2千万次,情况身好,没有发生过设备故障。现在 Our factory is the production of 7.5 kilowatts of DC motor professional factory. Motor stator used in silicon steel blanking is punching a single punch. Over the years, the lack of an ideal pick-up robot has not only affected production but also has been unsafe. Personal accidents have also occurred. To this end, we have trial-produced several take-off manipulator (referred to as the grinder), after continuous improvement, has been the basic stereotypes, installed in Neijiang Forging Machine Tool Factory production 80 tons open double column tilting presses (J23-80) Use, the effect is better. The earliest one has been used for more than a year, with a total work load of 20 million times. The equipment was in good condition and no equipment failure occurred. just now