【摘 要】
：
The ratio, of the temperature gradient at the solidification front to the solidification rate of solid-liquid interface, plays a large part in columnar grain gr
【机 构】
：
College of Metallurgy & Material Engineering
论文部分内容阅读
The ratio, of the temperature gradient at the solidification front to the solidification rate of solid-liquid interface, plays a large part in columnar grain growth. The transient temperature fields of directional solidification of Al-Ni-Co alloy were studied by employing a finite element method. The temperature gradient at the solidification front and the solidification rate were analyzed for molten steels pouring at different temperatures. The results show that with different initial pouring temperatures, the individual ratio of the temperature gradient at solidification front to the solidification rate soars up in the initial stage of solidification, then varies within 2,000-6,000 ℃.s.cm-2, and finally goes down rapidly and even tend to be closed to each other when the solidification thickness reaches 5-6 cm. The simulation result is consistent with the practical production which can provide an available reference for process optimization of directional solidified Al-Ni-Co alloy.
其他文献
Experimental research and numerical analysis were applied to study the ultimate load capacity (ULC) and reinforcement of circular-hollow-section N-joint. Four s
In order to achieve both the signal condition remote control and the work statute self-check through Ethemet, a distributed signal condition (DSC) system has be
Phase-field model was employed to quantitatively study the effect of convection on pattern selection and growth rate of 2D and 3D dendrite tip, as well as the e
Partially or fully regenerated catalytic cracking catalysts were prepared by gasifying the coke deposited on coked catalysts with a gaseous mixture of oxygen an
By using a yeast two-hybrid system,a yeast two-hybrid bait vector was constructed and identified for screening of the HPV18 E6-interacting proteins,and its effe
Spall fracture is a damage that occurs in a body when two rarefaction waves interact and produce enough dynamic tension breakage, and then the spall zone is fou
乳腺癌是癌症中引起妇女死亡的首要因素.本文采用绿色量子点作为荧光显色材料,建立了一种用于早期乳腺癌诊断的原位成像技术.利用生物素标记的抗HER2/neu抗体与乳腺癌细胞表
This paper investigates a reconstruction method for helical computed tomography which compensates for the motion artifacts in the thorax caused by patient breathing.The method takes into account a mot
In compact spinning with pneumatic groove, the computational fluid dynamic model, computed with parallel technologies & Fluent 6.3, is developed to simulate the
The regulated pollutants (CO, HC and NOx) and unregulated pollutants (volatile organic compounds and carbonyl compounds) , emitted from a dual fuel vehicle fuel