缝隙节流静压轴承又称为沟槽节流静压轴承。这种轴承的简图见图1,它的节流器是一狭长矩形缝隙,没有油腔。节流缝顺着圆周方向开,沿轴线开1或2列(周向缝),也可以顺着轴线方向开,沿圆周开数排(轴向缝)。由于轴向缝隙节流静压轴承的承载能力低、刚度小、流量大,所以很少采用。润滑剂可以是气体或液体,本文只探讨不可压缩流体润滑的计算,因此计算公式及结果 Slit-throttling hydrostatic bearings, also known as groove throttling hydrostatic bearings. Schematic diagram of this bearing shown in Figure 1, its throttle is a narrow rectangular slit, no oil chamber. Throttle slit along the circumferential direction to open along the axis of open 1 or 2 column (circumferential slit), you can also open along the axial direction, along the circumference of a few rows (axial slit). As the axial gap throttling static pressure bearing low carrying capacity, low stiffness, high flow, so rarely used. Lubricants can be either gas or liquid. In this paper, we only discuss the calculation of incompressible fluid lubrication, so the formulas and results