Photolysis studies on HCOOH and HCOO-in presence of TiO2 photocatalyst as suspension in aqueous medi

来源 :天然气化学(英文版) | 被引量 : 0次 | 上传用户:livos
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Photolysis studies on formic acid (HCOOH) and formate ion (HCOO-) in presence of TiO2,a photocatalyst,as suspension in water were carried out separately using 350 nm ultraviolet light.The products,such as H2,CO,CO2 and CH4,generated during the experiments were monitored with varying the ambient,light exposure time,and the concentration of HCOOH/HCOO-.The yields of CO in all these systems increased with light exposure time.In aerated systems,CO yields were higher in contrast to the deoxygenated (Ar-purged) systems under identical conditions.It is proposed apparently that the formation of CO is taking place during the chemical reduction of in-situ generated CO2,a photo-mineralized product of HCOOH/HCOO-,but not through the direct photodecomposition or photodehydration (CO+H2O) of solute molecules.The rates of CO formation during 1.3 M HCOOH photolysis in presence of TiO2 photocatalyst were evaluated to be 0.21 and 0.13 μlo/min in aerated and Ar-purged systems,respectively.As compared with HCOOH systems,the CO yields are lower when 0.2 M HCOONa was exposed to light under identical conditions.The CO growth rates were evaluated to be 0.07 and 0.046 μl-min-1 for aerated and deoxygenated HCOONa systems,respectively;moreover,the trend is quite similar to that of the HCOOH system.Under these conditions,the emission of H2 was also observed,and its yield was significantly higher in Ar-purged system as compared with the CO yields.However,in aerated system,the yields of these products were just opposite.The formation of low yield of methane was observed during photolysis of HCOOH/HCOO- ions.In CO2 ambient,the yields of CO and H2 varied drastically with time.
其他文献
The load-bearing capacity of ductile composite structures comprised of periodic composites is studied by a combined micro/macromechanical approach. Firstly, on
The mixing soft-segment WPU (waterborne polyurethane) polymer electrolytes were synthesized by using PEO (poly(ethylene oxide)) and PDMS (polydimethylsiloxane)
In this article, different population contributions of quartz powders to chemical reactivity in pozzolanic reaction were studied. Deconvolution software was use
In the presence of catalytic amount of In(OTf)3 (10 mol%), a series of aldimines reacted with tetraallyltin in a 2:1 molar ratio to afford the corresponding hom
Ce6-xHoxMoO15-δ(0.0≤x≤1.2) was synthesized by modified sol-gel method and characterized by diffe-rential X-ray diffraction(XRD), Raman, and X-ray photoelectr
The title compound was obtained by the flux method and its structure was determined.It crystallizes in monoelinic,space group P2/c with a=11.0024(17).b=9.2979(1
The most prestigious catalyst applied in natural gas (methane) non-oxidative conversion to petrochemicals is 6%Mo/H-ZSM-5.Chromium,molybdenum and tungsten are t
Block copolymer polystyrene-b-poly(acrylic acid)(PS-b-PAA) was used as structural template for the synthesis of CaCO3 microparticles. Through this procedure, ac
The inverse heat conduction method is one of methods to identify the casting simu-lation parameters. A new inverse method was presented according to the Tikhono
AIM: To investigate the inhibitory effect of natural taurine (Ntau) on portal hypertension (PHT) in rats with experimentally-induced liver cirrhosis (LC).METHOD