【摘 要】
：
The surfaces of the micron-sized HA particles were modified by in situ copolymerization of vinyl triethoxyl silane (VTES) and styrene (St). Then, the modified H
【机 构】
：
Department of Chemistry,State Key Laboratory of Plastic Forming Simulation and Die & Mould Technolog
论文部分内容阅读
The surfaces of the micron-sized HA particles were modified by in situ copolymerization of vinyl triethoxyl silane (VTES) and styrene (St). Then, the modified HA particles were compounded with HIPS. The results showed that the polystyrene (PS) macromolecules were grafted on the surfaces of HA particles during in situ copolymerization of VTES and St. Thereby, PS chains grafted on the HA surface enhance the compatibility between HA and HIPS, improve the dispersion of HA particles in HIPS matrix, and enhance the interfacial adhesion between HA and matrix. The stiffness, tensile strength and notch impact strength of HIPS/HA composites are improved at the same time. And there is a critical coating thickness of PS to the HA surf ace for the optimum mechanical properties of HIPS/HA composites.
其他文献
SmxGdyCe1-x-yO2-δ (x+y=0.2 and x=0, 0.04, 0.08, 0.12, 0.16, 0.2) nanopowders were prepared by a coprecipitation method. The zeta potential and sedimentation vo
Thin film of biodegradable calcium phosphate coated on threaded commercially pure titanium (cp-Ti) dental implants has been investigated as one of alternatives
This study examined the biological response of two porous calcium phosphate ceramics,hydroxyapatite (HA) and hydroxyapaptite/ β-tricalcium phosphate ( HA / β-
There is a great demand for in-situ real-time chemical sensors in the oceanographic research, to measure the chemical components under the deep sea. The ISE (Io
An integrated metallurgical model was developed to predict microstructure evolution and mechanical properties of iow-carbon steel plates produced by TMCP. The m
The hydroxyapatite/polylactide biocomposites were prepared by absorption process in liquid phase. The method avoided many disadvantages, such as interfusion of
Bioactive bone cements based on a paste-paste system for orthopaedic applications were developed consisting of hydroxyapatite ( HA ) filler particles in a metha
A thermodynamic model was developed to predict the distribution behavior of Cu,Fe,S,O,Pb,Zn,As,and the heat balance in a lead blast furnace.The modeling results
The finite element polycrystal model (FEPM) was extended and applied to simulate the development of the cold rolling textures of matrix aluminum in deformation
The co-precipitation method followed by ultrasound and heat treatment is a common way to prepare below 100 nm sized hydroxyapatite nanoparticles for biomedical