论文部分内容阅读
Microstructure and properties of in-situ TiB<sub>2</sub> particulates reinforced A356 co
【机 构】
:
StateKeyLaboratoryofMetalMatrixCompositesShanghaiJiaotongUniversityShanghai200030China,SchoolofMater
【出 处】
:
中国有色金属学会会刊:英文版
【发表日期】
:
2005年S3期
其他文献
<正>Al2O3-SiO2(sf)/AZ91D composite was fabricated by squeezing infiltration using preform made of crystallized aluminum silicate short fibers as reinforcement a
A set of device for electromagnetic separation (EMS) was designed and applied to process the continuous flowing melt. Tensile test was employed to compare effec
《棉纺织技术》期刊2000年第5期发表的“FA344型并卷机加装吹吸风装置”一文,对实现自动间歇吹气吸杂,减轻运转工人劳动强度,保持牵伸区清洁,减少车间含尘,稳定小卷质量起到
期刊
The metallic Zr65 Ni25 Ti10 (mole fraction, %) glass has been fabricated by a single roller melt-spinning method. The glass forming ability(GFA) and thermal sta
随着新型织机的广泛使用,对筒纱质量提出了更高的要求.电子清纱器以其清纱效率高,不刮毛纱线、能根据纱疵的不同粗度和长度进行清除等优点成为替代机械式清纱器的新一代产品.
精梳针织用纱要求条干和强力均匀,结杂少,纱疵少,因此,生产中必须做到工艺精细、管理严格.自1997年来,我公司生产CJ 14.5 tex针织用纱产品,产量逐年增加,质量保持稳定,深受用
Mechanical properties of Cf/Si-O-C composites prepared by hot-pressing assisted pyrolysis of polysil
Silicon oxycarbide composites reinforced by three-dimensional braided carbon fiber (3D-B Cf/Si-O-C)were fabricated via precursor infiltration and pyrolysis of p
<正>Mg-6Al-4RE-0.4Mn (mass fraction, %, RE=Ce rich mischmetal) alloy was prepared by steel mould casting technique. Solid solution and artificial aging (T6) wer
采用汉密尔顿转移指数的方法分析了不同比例的染色涤纶短纤维与棉纤维混纺纱径向纤维的分布规律,指出:涤棉色纺纱中涤纶纤维与棉纤维的混纺比不同,纱的结构将发生变化,纤维内