论文部分内容阅读
调查了湖南省内石煤开发生产链中几家典型企业——石煤发电厂、炼钒厂、煤渣制砖厂的辐射环境现状,监测了厂内及其周边的γ辐射剂量率、~(222)Rn浓度以及尾渣、渣砖、土壤、水中放射性核素含量,初步确定了这些环境物质中的放射性水平,评估了其对环境的影响,提出了治理和预防放射性污染的措施。
湖南省石煤开发生产链中放射性污染调查及防治
【摘 要】
：
调查了湖南省内石煤开发生产链中几家典型企业——石煤发电厂、炼钒厂、煤渣制砖厂的辐射环境现状,监测了厂内及其周边的γ辐射剂量率、~(222)Rn浓度以及尾渣、渣砖、土壤、水中放射性核素含量,初步确定了这些环境物质中的放射性水平,评估了其对环境的影响,提出了治理和预防放射性污染的措施。
【机 构】
：
核工业230研究所,湖南长沙,410007
【出 处】
：
铀矿冶
【发表日期】
：
2020年01期
其他文献
针对邯钢冷轧含酸碱废水处理系统不能有效控制出水CODCr和氨氮的难题,通过增设生物接触氧化池和优化运行工艺,将物化处理与生化处理相结合,采用了两级中和+混凝+生物接触氧化
Hydrogen storage thermodynamics and dynamics of La-Mg-Ni-based LaMg12-type alloys synthesized by mec
期刊
Hydrogenation behaviors and characteristics of bulk Ti-6Al-4V alloy at different isothermal temperat
The bulk Ti-6Al-4V alloy was hydrogenated at the temperature range of 723-973 K,and the hydrogen absorption characteristics and hydrogen absorption kinetics wer
The lithium-ion capacitor is a promising energy storage system with a higher energy density than traditional supercapacitors.However,its cycling and rate perfor
Microstructure quantification of Cu-4.7Sn alloys prepared by two-phase zone continuous casting and a
Microstructures of Cu-4.7Sn (％) alloys prepared by two-phase zone continuous casting (TZCC) technology contain large columnar grains and small grains.A compound
The hot deformation behavior of Al-Cu-Li alloy was investigated by hot compression tests in the temperature range of 340-500 ℃ with strain rate of 0.001-10.000
Microstructure and wear resistance of CoCrNbNiW high-entropy alloy coating prepared by laser melting
The defect-free CoCrNbNiW high-entropy alloy coating was successfully prepared by laser melting deposition,and its microstructure and wear resistance were inves
The Bi0.5Sb1.4-xNaxIn0.1Te3 (x =0.02-0.20) alloys were fabricated by high vacuum melting and hotpressing technique.The phase structures and morphology of the bu
Ultrafine rare-earth oxides (REOs) are widely applied in all fields of daily life,but the conventional preparation methods are limited by a long procedure,low e
Cu matrix composite materials reinforced with B4C particle at four different contents (1.5 wt％,3.0 wt％,4.5 wt％ and 6.0 wt％) and also CuAl matrix composites with 13