我厂使用的刨边机是济南生产的,其结构型式同各兄弟厂目前使用的差不多。此机原来没有自动送料装置,也没有自动校板系统。使用时,在钢板用吊机吊到预刨架上之后,需要三至四人将板慢慢推入刨台,而且还往往由于板边参差不齐,以及由于钢板边线不平行于刨台边线,而必须化费很多时间,以人力将钢板加以调整。在多张钢板迭刨时,钢板张数愈多,则 I used in the plant planing machine is produced in Jinan, the structure of the same type with the brothers plant currently used almost. This machine had no automatic feeding device, there is no automatic school system. When used, it is necessary for three to four people to push the board slowly into the planing table after the steel plate is hung on the pre-pallets by the crane, but also often due to the unevenness of the board edges and because the edge of the board is not parallel to the edge of the table , But must spend a lot of time to manpower to adjust the plate. In a number of steel Diego Planer, the more the number of sheets, then