【摘 要】
：
This study demonstrates a homogenization approach via a modified state-based peridynamic(PD)method to predict the effective elastic properties of composite materials with periodic microstructure.The procedure of modeling the PD unit cell(UC)of continuous
【机 构】
：
Aerospace Structure Research Center,School of Aeronautics and Astronautics,Shanghai Jiao Tong Univer
论文部分内容阅读
This study demonstrates a homogenization approach via a modified state-based peridynamic(PD)method to predict the effective elastic properties of composite materials with periodic microstructure.The procedure of modeling the PD unit cell(UC)of continuous fiber-reinforced composite is presented.Periodic boundary conditions are derived and imple-mented through the Lagrange multiplier method.A matrix-dominated approach for modeling the interphase properties between dissimilar materials is proposed.The periodicity and continuity assumptions are employed to determine the stress and strain fields,as well as the effective elastic properties.The PD-UCs of square and hexagonal packs as well as the 0/90 laminate microstruc-ture are modeled and compared with the analytical,numerical and experimental results from the literature.Good agreement of predicted effective properties can be observed.Unlike other PD homogenization approaches,the effective material properties can be directly and individually obtained from simple loading conditions.
其他文献
In this work,a novel constitutive model is developed within the framework of fractional plasticity to delineate the coupling between inelastic deformation and damage of quasi-brittle materials.Faced with the common challenge of determining plastic flow di
Engineering structures made of ceramic matrix composites(CMCs)usually suffer from cyclic loads during service,which could lead to disastrous failures.This work focuses on the fatigue behavior of a 2.5D C/SiC composite under tension-tension cyclic loading.
The contact stiffness of the joint surface directly affects the static and dynamic mechanical behavior,and accuracy of the machine tool.A new elastoplastic contact stiffness model is proposed by considering continuous and smooth contact characteristics an
A wavelet-based boundary element method is employed to calculate the band struc-tures of two-dimensional phononic crystals,which are composed of square or triangular lattices with scatterers of arbitrary cross sections.With the aid of structural periodici
In the process of shale gas exploitation,there exits two difficult problems:one is the real numerical simulation of a tremendous number of holes in actual shale;the other is the fluid-solid coupling problem involved in holes,where the difficulty of transi
We study the response of a composite beam(unimorph)with a piezomagnetic layer and a piezoelectric semiconductor layer under a transverse magnetic field.A one-dimensional model for coupled bending and extension of the beam is derived from the three-dimensi
Dermal armor,such as fish scales or armadillo osteoderms,has been known to exhibit high performance and good flexibility defending against attack.The top layer of the dermal armor usually consists of a segmented hard bony layer.The soft inner layer compos
A geometrically nonlinear topology optimization method for continuum structures is proposed based on the independent continuous mapping method.The stress constraint problem is studied due to the importance of structural strength in engineering application
无源光互连数据中心由于其低成本、低功耗和高速率受到了广泛关注.在无源光互连数据中心中,同时可用的信道数目不能超过可用波长数,波长数量也限制了总吞吐量.为了减少光互连数据中心的波长需求、提高光互连数据中心的波长利用率与可扩展性,将NRZ+ Manchester信号结合偏振复用应用于光互连数据中心,实现机架内4个服务器共享一条波长,从而将吞吐量提升4倍.通过仿真验证了该方案在10 Gbit/s速率下能够只使用16个波长实现机架内64个服务器的光互连,在25 Gbit/s速率下只使用8个波长就能够实现32个服务
研究了地表反照率对天空偏振模式的影响.针对目前缺乏实际环境下不同时间、不同地点单一影响因素的定量测试研究,先运用libRadtran二次开发软件,仿真分析不同地表反照率下的天空偏振模式,然后利用图像式测试系统,分别在草地和沥青地表、海洋和沥青地表进行同步异地测试,定量分析地表反照率对偏振方位角和偏振度的影响.结果 表明:地表反照率对偏振方位角分布基本没有影响,分布始终稳定;而地表反照率对偏振度数值有较大的衰减作用,在同一天内同一时刻下,地表反照率越大,最大偏振度值越小;地表反照率相差越大,最大偏振度值的平