论文部分内容阅读
首先进行外观检查,清除积水及淤泥,并进行冲洗,如无外观破损及零部件缺失,按照前述农业机械被淹进水后的维护及保养要求以及联合收获机定期保养要求对整机进行维护。随后进行试运转,先在怠速下运转5~10分钟,观察其运转情况,如无异常,缓慢加大油门,使转速保持在1000~1200转/分,待水温达到50℃以上,再逐步提高发动机转速到额定转速,空转10~20分钟。检查各仪表盘指示是否正常。带机组试运转。关闭发动机,用手转动传动皮带轮或脱离滚筒,使整个工作部件转动。若各工作部件都正常
First of all, the appearance of inspection, remove water and sludge, and washed, without the appearance of damage and missing parts, in accordance with the aforementioned agricultural machinery was flooded into the water after the maintenance and repair requirements and the maintenance requirements of the integrated harvester 整机 maintenance . Followed by the trial run, first run at idle for 5 to 10 minutes to observe the operation, if no exception, slowly increase the throttle, the speed maintained at 1000 ~ 1200 rev / min until the water temperature reached 50 ℃ above and then gradually increase Engine speed to rated speed, idling 10 ~ 20 minutes. Check each dashboard instructions are normal. With unit test run. Turn off the engine, hand drive the transmission pulley or from the drum, so that the entire working parts rotation. If the working parts are normal