【摘 要】
：
To investigate the water-inrush process due to floor heave, simulation model was made and factors of mining height, immediate roof strength, water pressure, depth and strength of confiningbed, excavation step distance and bury depth were analyzed by using
【机 构】
：
School of Energy Science and Engineering, Henan Polytechnic University, Jiaozuo 454010, China
论文部分内容阅读
To investigate the water-inrush process due to floor heave, simulation model was made and factors of mining height, immediate roof strength, water pressure, depth and strength of confiningbed, excavation step distance and bury depth were analyzed by using UDEC software. Five zones theory (containing two maximum main stress circles and three maximum main stress stratiform zones) along excavation direction was proposed,and two-ends-fixed beam mechanical model in maximum main stress circle was established. It is found that water inrush always occurs at the end of the beam where shear stress is higher, that is to say, it always occurs at near the starting cut and working face.Water pressure, height and strength of confiningbed are the determined factors, and mining height, immediate roof strength, excavation step distance and bury depth effect water inrush process due to floor heave.
其他文献
Based on optimized forecast method of unascertained classifying, a unascertained measurement classifying model (UMC) to predict mining induced goaf collapse was established. The discriminated factors of the model are influential factors including overburd
Based on the shell (jieke) theory investigation of accident prevention in coal mine, submited a new definition of safety management shell, and analyzed causes on the lack of accident prevention, then pointed that the strength of research and practice of s
Introduced the application and development status of coal gasification technology in China. The most widely used coal gasification technology in China is the atmospheric fixed-bed gasifier, its total number is about 9 000. About 30 pressurized fixed-bed g
The wavelet transformation is applied to the high-current transformer.The high-current transformer elaborated in the paper is mainly applied to the measurement of AC/DC high-current.The principle of the transformer is the Hall direct-measurement principle
An Equivalent-Resistance based Analysis Method (ERAM) was proposed,which can convert the Inductor-Disconnected Discharge (IDD) behavior of the IntrinsicallySafe Buck Converter (ISBC) into that of an Equivalent Simple-Inductive-Circuit (ESIC).According to
The developed process and theoretical achievement for the technology of controlling surface subsidence by grouting separated layer in overburden is summarized in this paper. The research progress of the technology is discussed synthetically on the basis o
The coincidence of relevant factors, e.g. oxygen absorption quantity, weight increment, water soluble iron ions and sulfate ion of sulfide ore samples in the oxidation process, was tested through experiment. Based on a large number of tests for a group sa
The properties of broken rock before and after grouting reinforcement are studied. Testing results show that grouting can raise the residual strength of broken rock, and the broken rockness by grouting can keep the steady supporting capacity within a rela
Gateway supporting in long-wall mining has been a problem that restri cts the mine production and safety, the paper sets up an interaction model betwe en support and surrounding rock (rock mass structure) and probes the elementary theory about ground pres
Melt blends of low-density polyethylene(LDPE), ethylene vinyl acetate(EVA) and coal with various compositions were prepared through reactive extrusion. The rheological behaviour was studied with respect to the effect of blend ratio, shear rate using a rhe