论文部分内容阅读
打造“三型”报社谋求快速发展
【出 处】
:
新闻世界
【发表日期】
:
2003年7期
其他文献
文中介绍了分别采用聚酰亚胺和CVDSiO2作层间介质,进行2μm×2μm通孔的刻蚀和铝双层布线,其成品率均可达到100%,介质对一次铝的覆盖完整率可达95%以上,层间绝缘电压大于250V。
Theoretical analysis on ignition-proof of AZ91D alloy added with Ce was studied. The effect of Ce on burning temperature was investigated. The burning temperatu
针对一种双平衡结构的无源CMOS混频器,分析了它的转换增益、噪声系数和线性等参数,在此基础上,推导了它的电路设计方程.设计了该混频器应用于2.4 GHz无线局域网(WLAN)的电路
Effect of phosphorus on the microstructure and high temperature properties of a cast Ni-base superalloy M963 has been investigated. SEM observation and EDS anal
In this paper, spring steel-60Si2Mn and stainless steel-1Cr18Ni9Ti were rolled one pass in the semi-solid state. The microstructural evolution during rolling of
The X-ray diffraction peak-shift method was introduced into the determination of deformation fault probability (α)of Fe-Mn-Si alloys with various Mn contents a
Effect of Pre-strain on the Transformation and Recovery Behaviours of a Ti44Ni47Nb9 Shape Memory All
The recovery strain, stress and transformation temperature of different pre-strained specimens of Ti44Ni47Nb9 were investigated by tensile test and electrical r
期刊
Preparation and Photochromic Properties of Hybrid Thin Films Based on Heteropolyoxometallate and Pol
series of photochromic hybrid films were prepared through entrapping Dawson type tungsten heteropolyoxometallates (P2W18O626-) and molybdenum heteropolyoxometal
Solution of an Inverse Problem of Heat Conduction of 45 Steel with Martensite Phase Transformation i
In order to simulate thermal strains, thermal stresses, residual stresses and microstructure of the steel during gas quenching by means of the numerical method,