论文部分内容阅读
6 mm thick ZK60 and ZK60-Y alloy plates were successfully friction stir welded (FSW) at a tool rotation rate of 1200 r/min and a traverse speed of 100 mm/min. FSW resulted in the dissolution of MgZn2 particles in the ZK60 and the breakup and dispersion of W-phase (Mg3Zn3Y2) particles in the ZK60-Y alloy, thereby leading to a decrease in the hardness of the nugget zone (NZ) for the ZK60 alloy and an increase in the hardness of the NZ for the ZK60-Y alloy, respectively. While two FSW joints exhibited similar joint effciency (87%-89% of ultimate tensile strengths of the parent materials), the yield strength of the FSW ZK60-Y joint was substantially higher than that of the FSW ZK60 joint. The fracture occurred in the NZ and the heat affected zone for the ZK60 and ZK60-Y joints, respectively, which were consistent with the lowest hardness distribution of the welded joints.
6 mm thick ZK60 and ZK60-Y alloy plates were successfully friction stir welded (FSW) at a tool rotation rate of 1200 r / min and a traverse speed of 100 mm / min. FSW resulted in the dissolution of MgZn2 particles in the ZK60 and the breakup and dispersion of W-phase (Mg3Zn3Y2) particles in the ZK60-Y alloy, leading to a decrease in the hardness of the nugget zone (NZ) for the ZK60 alloy and an increase in the hardness of the NZ for the ZK60 -Y alloy, respectively. While two FSW joints see similar joint effciency (87% -89% of ultimate tensile strengths of the parent materials), the yield strength of the FSW ZK60-Y joint was substantially higher than that of the FSW ZK60 joint . The Fatal happened in the NZ and the heat affected zone for the ZK60 and ZK60-Y joints, respectively, which were consistent with the lowest hardness distribution of the welded joints.