【摘 要】
:
The development of the phytoplankton community was studied in the Jiaozhou Bay during the spring to neap tide in August 2001, through three cruises and a 15 d c
【机 构】
:
Marine Ecosystem Dynamic Laboratory,Key Laboratory of Marine Ecology & Environmental Science,Institu
论文部分内容阅读
The development of the phytoplankton community was studied in the Jiaozhou Bay during the spring to neap tide in August 2001, through three cruises and a 15 d continuous observation. This investigation indicates that diatom cell abundance increased sharply following the end of a spring tide, from 9 cells/cm3 to a peak of 94 cells/cm3. The dominant species composition and abundance show a quick species sequence from spring to neap tide, and the dominant species at the start phase is Skeletomena costatum, then changes to Chaetoceros curvisetus, finally it changes to Eucampia zodiacus. Silicate concentration increases during spring tide, as a result of nutrient replenishment from the water-sediment interface, its initial average concentration in neap tide is 1.39 μmol/dm3 and reached the peak average concentration of 8.40 μmol/dm3 in spring tide. But the nitrogen concentration dropped due to dilution by the low nitrogen seawater from the Huanghai Sea, its initial average concentration in neap tide is 67 μmol/dm3 and decreased to the average concentration of 54 μmol/dm3 in spring tide. The degree of silicon limitation was decreased and phytoplankton, especially diatoms, responds immediately after nutrient replenishment in the water column. Skeletonmea costatum, as one of the dominant species in the Jiaozhou Bay, shows a quicker response to nutrient availability than Eucampia zodiacus and Chaetoceros curvisetus. It is proposed that dominant species composition and water column stability synchronously determine the development of phytoplankton summer blooms in the Jiaozhou bay.
其他文献
We describe a new titanosaurian sauropod dinosaur, Borealosaurus wimani gen. et sp. nov., based on a distinctive mid-distal caudal vertebra from the early Late
This paper presents a new approach of designing the revolving cutter with constant pitch, and pro-vides geometric models. The corresponding models in the non-nu
This study was undertaken to construct a preliminary spatial analysis method for building an urban-suburban-rural category in the specific sample area of centra
Ecological restoration is widely employed from tens to millions of hectares in space, and from tens of days to thousands of years in time, which forces consider
Deformation twins and stacking faults were observed in nanostructure Al-Mg alloys subjected to high pressure torsion. These observations are surprising because
Japan ranks fifth in the world for the number of large dams. Environmental impacts of large dams are known, such as enormous losses of water or disruption of fi
Several methods for analysis of dissolved total phosphorus in seawater were reviewed. Discussions were focused on UV irradiation and persulphate oxidation metho
The microstructure and crystallographic texture characteristics of an extruded ZK60 Mg alloy subjected to cyclic extrusion and compression (CEC) up to 8 passes
The physical characteristics and microstructure of the fluoride film formed during activation were investigated using SEM, XPS and SAM, and its stability in ele
Process of warm tube hydroforming was experimentally investigated for forming an AZ31B magnesium alloy tubular part with a large expansion ratio. Effects of tem