论文部分内容阅读
在正常情况下,锻压生产在一定程度上取决于模锻工具及其存放和登记组织管理程度。因此,在机器制造企业大多把大型锻模存放在可拉出的托板(隔板)的架子上。通常这种架子配置在起重设备达不到所谓死区。锻模用车间起重机放置在架子上,隔板可拉到起重机的操作范围。这种型式的架子由乌留平斯克列宁起重机厂生产,用于存放重达5吨的大型锻模,但机械化水平低,不完全符合安全技术要求。莫吉廖夫机器制造设计与工艺研究所研制了三种规格的带可拉出隔板的通用机械化架子,而且根据工艺设备的平面布置及其起重运
Under normal circumstances, forging production to a certain extent depends on the forging tool and its storage and registration organization management. As a result, most machine builders store large forging dies on the shelves of drawable pallet (bulkhead). This type of shelf is usually configured so that the crane can not reach the dead zone. The die forging shop floor crane placed on the shelf, the separator can be pulled to the crane’s operating range. This type of shelves, produced by the crane factory in Ulyanovsk, Lenin, is used to store large forging dies weighing up to 5 tons but with low mechanization level and not fully meeting safety requirements. Mogilev Machine Design Institute of Technology has developed three kinds of general-purpose shelves with pull-out bulkheads, and according to the layout of process equipment and lifting