Effects of Sc doping on electrical conductivity of BaZrO3 protonic conductors

来源 :稀有金属(英文版) | 被引量 : 0次 | 上传用户:bylee
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
BaZr1-xScxO3-0.5x (x=0.07,0.10,0.13,0.16) powders were prepared by solid-state reaction method,and ZnO was used as sintering aid.Samples with different amount of ZnO additive were sintered at 1450 ℃ for 6 h in air.Single cubic perovskite phase proton conductors were obtained.Conductivity was measured by electrochemical workstation.It was shown that Sc doping could increase conductivity through enhancing the carrier concentration in the material,but excessive Sc content might decrease the carrier concentration because of its charge compensation.ZnO had an influence on carrier concentration and mobility and affected the electrical conductivity.2 mol% ZnO and 13 mol% ScO1.5 doped sample showed the highest DC conductivity of 3.6 × 10-3 S·cm-1 tested at 800 ℃ in wet hydrogen atmosphere.
其他文献
Ship-mounted container cranes are challenging industrial applications of nonlinear pendulum-like systems with oscillating disturbance which can cause them unsta
在费率厘定中,当索赔次数数据存在过离散(over-dispersion)特征时,通常会采用负二项回归模型,但当索赔数据中同时又出现零膨胀(zero-inflated)问题时,负二项回归模型不再适合
Isothermal compression of the Ti-6Al-4V alloy at the deformation temperatures of 950 and 980℃,height reductions of 30% and 60%,and strain rates of 0.001,0.010,0.
在实际顶点覆盖选址过程中,经常会遇到如下的情形:在需要服务的边的个数未知的前提下,决策者需要决定在哪里建立初始的设施(或设施集),同时还要求,当新的设施建立后,前面已经建立的设
The electrochemical migration (ECM) behavior of the electrically conductive adhesives (ECAs) filled with pure Ag powder or Ag-plated Cu composite powder with va
The delayed-state-derivative feedback (DSDF) is introduced into the existing consensus protocol to simultaneously improve the robustness to communication delay
Submicron diamonds were co-deposited on aluminum substrates with copper from the acid copper sulfate electrolyte by electrolyte-suspension co-deposition.After s
New ultra-lightweight sludge-red mud ceramics (ULS-RMC) were prepared by red mud (RM),clay and dried sewage sludge (DSS).The properties and mechanism of RM in t
A fluidized bed jet milling process was used to make micro-fine high Nb-containing TiAl alloyed powders from the chippings obtained by crushing the Ti-45Al-8.5N
To determine mirror surface finishing conditions and efficient and economical superfinishing conditions for pure titanium and titanium alloys,an abrasive film i