刴料是咱們鍛工經常碰到的一項工作,刴不好,很費工費料。我在实际工作中摸索到一些刴料的經驗,可以使刴后的端头斜面小或是平整,因而可以节約大量的金屬材料。現在把我所采用的方法介紹如下,供大家参考。 刴刀規格:下面介紹的兩种刴刀用来刴圓料、方料都可以。圖1是第一把刴刀,長度l等于1.2～1.3方料边長(或圓料直徑);高度H等于2/5方 刴 material is a work we often encounter a forge, 刴 not good, it is labor costs. In the actual work I have found some experience in the material, can make the tip of the tail after the bevel is small or flat, which can save a lot of metal materials. Now I introduce the method used as follows, for your reference. Trowel specifications: The following describes the two trowels used to 刴 round material, materials can be. Figure 1 is the first trowel, the length l is equal to 1.2-1.3 side material length (or round diameter); height H is equal to 2/5