论文部分内容阅读
在没有特别设備的许多制造厂中,高品质内啮合齒輪用小插刀是很难制造的,许多工厂所采用的基圆圆柱滚制式设備,不能够磨制尺寸小於16～20公厘的小插刀。下面介绍的设備,可用以磨制高品质的直径4～20公厘之连柄插刀。此设備可应用在任何万能工具磨床上,设備的生产率和插刀齒的模数及齒数有关,一班可生产5～10个插刀。此设備如[图一]所示(无分度机耩)。设備之支座1以滑块13固定於万能工具磨床上,在轴2上之平板12可以向两个方向转20°以内之角度,转至所要求之位置后再用螺钉3固定之。在平板12上固定着角棱柱形导轨11,导轨11靠滚珠9上,同时导轨10便能沿着此滚珠而滑动。设備之架子5固定在滑板4上,并与导轨10相连而能作
In many manufacturing plants where there are no special equipment, high-quality small-sized blades for internal gear are very hard to manufacture. Many factory-based cylindrical roller-type equipment can not grind small blades with sizes less than 16 to 20 mm Gadget. The equipment described below can be used to grind high-quality 4 to 20 mm diameter connecting blades. The device can be applied to any universal tool grinder, the productivity of the equipment and the teeth of the module and the number of teeth, a group can produce 5 to 10 inserts. This device is shown in Figure 1 (without index 耩). The support 1 of the device is fixed to the universal tool grinder with a slider 13. The flat plate 12 on the shaft 2 can be rotated by 20 ° in both directions to the desired position and then screwed 3 to it. On the flat plate 12 is fixed a rectangular prism-shaped guide rail 11, the guide rail 11 is placed on the ball 9, and the guide rail 10 is slidable along the ball. The equipment rack 5 is fixed on the slide plate 4 and can be connected to the guide rail 10