【摘 要】
：
On the basis of quantitative evaluation of susceptibility to solidification cracking with Trans-Varestraint-Test, the microstructures of two stainless steels of
【机 构】
：
Nanjing University of Aeronautics and Astronautics,Harbin Welding Institute
论文部分内容阅读
On the basis of quantitative evaluation of susceptibility to solidification cracking with Trans-Varestraint-Test, the microstructures of two stainless steels of 316L and alloy 800H with different Creq/Nieq ratios during solidification process were analyzed with several methods. It is concluded that the susceptibility to solidification cracking of 316L-stainless steel is much lower than that of alloy 800H due to different solidification behaviors of the weld metal of the two materials. The weld metal of alloy 800H solidifies in the form of primary austenite whose boundaries are straight and smooth and easily wetted by low melting-point liquid phases, which increases the susceptibility to solidification cracking; while the 316L weld metal solidifies into primary austenite/ferrite. Owing to a series of dynamic microstructure changes during solidification such as peritectic reactions, migration of austenitic boundaries and nailing of δ-ferrite to the boundaries, the grains become finer, the orientations of columnar grains get disordered and the boundaries are curved and complex. Also high temperature δ-ferrite exists, segregation of impurities at boundaries decreases and the boundaries are hard to be wetted by liquid films, which reduces the cracking susceptibility.
其他文献
A new hardfacing process, reactive braze coating process (RBCC) was studied, and ( TiC + Cr3 C2 ) /Fe composite coatings were prepared by RBCC using carbon, Cr3
According to the feature of arc voltage control in welding steel using pulsed MIG welding, a correction factor based double model fuzzy logic controller (FLC) w
The microstructure and hardness of the HAZ in a 800 MPa grade ultra-low-carbon microalloyed steel were studied.The results indicate that the heat affected zone
In order to improve the efficiency of data distributed management service in distributed interactive simulation based on high level architecture (HLA) and to re
科技期刊编辑在科技期刊的运作过程中起着关键的作用。随着科学技术的进一步发展,科技期刊编辑应特别强调具有工程意识,即综合意识、协调意识、科学洞察力、超前意识、效益意
This paper attempts to solve the complexity of scheduling problems and meet the requirement of the ever-changing manufacturing environment. In this paper, a new
This paper is based on two existing theories about automatic indexing of thematic knowledge concept. The prohibit-word table with position information has been
混凝土离析现象使混凝土结构不均匀,出现孔洞和蜂窝状结构,严重的离析使混凝土结构明显分层,大大降低了混凝土结构的强度和使用性能.本文从流变学的角度出发分析和阐述了影响
现在大型高层建筑越来越多,其对基础要求也越来越高.钻孔桩基础作为一种深基础,得到了广泛的应用.本文介绍了钻孔桩施工工艺流程和施工中要注意的问题,并对在钻孔桩中经常出
The Canetti-Krawczyk (CK) model is a formalism for the analysis of keyexchange protocols, which can guarantee many security properties for the protocols proved