We report here the structural,surface morphology,mechanical,and current-voltage characteristics of Zn1-xMxO ceramic samples with various x and M(0.00≤x≤0.20,M=Ni,Cu).It is found that the considered dopants do not influence the well-known peaks related to the wurtzite structure of ZnO ceramics,while the shapes and the sizes of grains are clearly affected.The average crystalline diameters deduced from the SEM micrographs are between 2.06 μm and 4.8 μm for all samples.The oxygen element ratio is increased by both dopants.Interestingly,the potential barrier can be formed by adding Cu up to 0.20,while it is completely deformed by 0.025 Ni addition.The breakdown field can be enhanced up to 4138 V/cm by 0.025 Cu addition,followed by a decrease with further increase of Cu up to 0.20.On the other hand,a gradual decrease in Vickers microhardness is reported for both dopants,and the values in the Ni samples are higher compared to those in the Cu samples.The electrical conductivity is generally improved by Ni,while the addition of Cu improves it only in the over doped region(≥0.10).These results are discussed in terms of the differences of valency and ferromagnetic ordering. We report here the structural, surface morphology, mechanical, and current-voltage characteristics of Zn1-xMxO ceramic samples with various x and M (0.00≤x≤0.20, M = Ni, Cu) .It is found that the considered dopants do not influence the well-known peaks related to the wurtzite structure of ZnO ceramics, while the shapes and the sizes of grains are clearly affected. the total apoptosis deduced from the SEM micrographs are between 2.06 μm and 4.8 μm for all samples. oxygen element ratio is increased by both dopants.Interestingly, the potential barrier can be formed by adding Cu up to 0.20, while it is completely eliminated by 0.025 Ni addition. breakdown-volume can be enhanced up to 4138 V / cm by 0.025 Cu addition, followed by a decrease with further increase of Cu up to 0.20. On the other hand, a gradual decrease in Vickers microhardness is reported for both dopants, and the values ​​in the Ni samples are higher than those in the Cu samples. electrical conductivity is genera lly improved by Ni, while the addition of Cu improves it only in the over doped region (≧ 0.10). These results are discussed in terms of the differences of valency and ferromagnetic ordering.