2. 您的位置
3. 首页
4. 期刊论文
5. Welding temperature field analysis for featheredged cylinder based upon conformal transformation

Welding temperature field analysis for featheredged cylinder based upon conformal transformation

来源 :中国焊接：英文版 | 被引量 : 0次 | 上传用户：zhouyulong456

【摘 要】

：

<正>The accurate calculation and measurement of welding temperature field is an important precondition for welding metallurgical analysis and welding process co

【作 者】

：

张国栋 张富巨 

【机 构】

：

DepartmentofMaterialEngineering

【出 处】

：

中国焊接：英文版

【发表日期】

：

2006年4期

【关键词】

：

薄边汽缸 焊接 温度场 共形变换 热循环 welding temperature field  conformal transformation  cylind 

下载到本地 , 更方便阅读

下载此文 赞助VIP

声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架

论文部分内容阅读

<正>The accurate calculation and measurement of welding temperature field is an important precondition for welding metallurgical analysis and welding process controlling.In this paper,the conformal transformation is firstly used to analyze the weldin

其他文献

Microstructures of 2219 twin wire welded joints

With thick plates of 2219 high-strength alloy, the microstructures of welded joints with twin wire MIG welding were analyzed. Experimental results show that no

期刊

铝合金双丝电弧焊焊接接头显微结构aluminum alloy welded joint twin wire welding microstruet

Low temperature bonding of LD31 aluminum alloys by electric brush plating Ni and Cu coatings

Soldering of LD31 aluminum alloys using Sn-Pb solder paste after electric brush plating Ni and Cu coatings was nvestigated. The technology of electric brush pla

期刊

ld31铝合金电刷电镀低温焊接镍铜LD31 aluminum alloy electric brush plating coating sold

Friction stir welding of copper alloys

Copper plates,brass plates and copper/brass plates were friction stir welded with various parameters.Experimental results show that the microstructure of the we

期刊

摩擦移动焊铜合金微观结构焊接参数friction stir welding copper brass grain

Transient finite element analysis of ultrasonic welding of PEEK

期刊

超声波焊接有限元聚醚醚酮PEEKultrasonic welding finite element polyetheretherketone

A study on reactive braze coating of （TiC＋Cr3C2 ）／Fe composite coatings

A new hardfacing process, reactive braze coating process (RBCC) was studied, and ( TiC + Cr3 C2 ) /Fe composite coatings were prepared by RBCC using carbon, Cr3

期刊

反应铜焊电镀处理复合层微结构铁碳化钛reactive braze coating process (TiC+Cr_3C_2)/Fe composi

Calculation of temperature field near stagnation point in explosive welding

期刊

爆炸焊接绝热压缩温度场有限差分方法explosive welding adiabatic compression temperature field

Influence of the configuration of pin on the quality of plastics FSW joints

期刊

FSW销结构搅拌摩擦焊质量控制configuration of pin plastics friction stir welding weld q

Study on the microstructure and hardness of in-service welded joint of X70 pipeline steel

Hydrogen induced cracking(HIC) is one of the main problems of in-service welding onto active pipeline.Microstructure and hardness of welded joint have a vital e

期刊

焊接X70管道不锈钢微观结构硬度in-service welding X70 pipeline steel microstructure hard

Role of temperature gradient in liquid／solid phase solution-diffusion bonding

The liquid-film solution-diffusion bonding of ZCuBe2.5 alloys was conducted using Cu-based alloy powders. The tensile strength of the bonding time decreases and

期刊

扩散焊接温度梯度压焊时间液态膜铜合金solution-diffusion welding temperature gradient liquid/

Numerical simulation of small section rectangular tube in parallel welding

The welding temperature field and deformation of parallel arrangement small-section rectangular tubes is calculated by using a non-contact model. After comparin

期刊

矩形管接触点应变能力焊接技术small-section rectangular tube contact direct constraints me