【摘 要】
：
Based on the steady-state solution of finite-state birth and death process, the principle of line configuration for shared multi-channel system is analyzed. Cal
【机 构】
：
School of Electronic Information Engineering, School of Information and Communications Engineering,S
论文部分内容阅读
Based on the steady-state solution of finite-state birth and death process, the principle of line configuration for shared multi-channel system is analyzed. Call congestion ratio equation and channel utilization ratio equation are deduced, and visualized data analysis is presented. The analy-sis indicates that, calculated with the proposed equations, the overestimate for call congestion ratio and channel utilization ratio can be rectified, and thereby the cost of channels can be saved by 20% in a small system.With MATLAB programming, line configuration methods are provided. In order to generally and intuitively show the dynamic running of the system, and to analyze,promote and improve it, the system is simulated using M/M/n/n/m queuing model and Monte-Carlo method. In addition, the simulation validates the correctness of the theoretical analysis and optimizing configuration method.
其他文献
To simulate steady airflows inside of wall-flow diesel particulate filters (DPF) with different reverse blowing pipes collocation, a mathematical model of the f
Due to complicated rock structure and environment, a prototype test for a tunnel-type anchorage is infeasible. Based on the rock mass parameters from tests, a t
Neutral Beam Injection control system (NBICS) is constructed to measure the plasma current, Magnet current, vacuum pressure, cryopump temperature, control water
This paper investigated the performances of a well-known car-following model with numerical simulations in describing the deceleration process induced by the mo
本文通过总结近年来国际上对水泥净浆、砂浆和混凝土自缩性能的研究成果分析混凝土自缩的起因及影响因素，并总结一些减小混凝土自缩的途径。
Considering the steering characters of one type of wheeled armored vehicle, a brushless direct current (DC) motor is adapted as the actuator for steering contro
Combining with the development of automated manual transmission (AMT), the various throttle control demands are analyzed under different working conditions of A
光伏电池的生产工艺一般需要经过硅片检测、清洗制绒、扩散制结、去磷硅玻璃和镀减反射膜、丝网印刷、快速烧结等步骤。在这些步骤中，扩散制结是光伏电池生产过程中最基本也最
The Dynamic Matrix Control (DMC) algorithm for integral processes is investigated in this paper. The reason why the original DMC algorithm cannot be applied to