【摘 要】
：
Although emperipolesis exists in infectious liver diseases, the diagnostic value of emperipolesis in hepatitis B is not known exactly.The aim of this study was to evaluate histological characteristics
【机 构】
：
Department of Pathology and Hepatology Institution, Beijing 302 Hospital, No.100 Xisihuan Middle Roa
【出 处】
：
第十四届中国体视学与图像分析学术会议
论文部分内容阅读
Although emperipolesis exists in infectious liver diseases, the diagnostic value of emperipolesis in hepatitis B is not known exactly.The aim of this study was to evaluate histological characteristics and laboratory parameters of emperipolesis in hepatitis B.Totally 402 patients with hepatitis B and other liver diseases were processed in a retrospective assessment.Inflammatory severity of hepatitis B was evaluated with Ishak Scoring System.Immunofluorescent staining was performed for CD8 (T cells) , CD20 (B cells), CD56 (NK cells), CD68 (macrophages) and MPO (neutrophils).Emperipolesis was observed in 74.0% of patients with chronic hepatitis B (CHB) and 82.8% of patients with acute hepatitis B (AHB).In emperipolesis, CD8 + T cell was the main cell type.Patients with emperipolesis in CHB got high scores of inflammatory activity.Among patients with CHB, emperipolesis was present with higher serum ALT, AST and GGT levels.HBV DNA Load in patients with emperipolesis was as 10 times high as those without.HBeAb was significantly related with the evidence of emperipolesis.In hepatitis B, emperipolesis was associated with severity of liver injury.The presence of emperipolesis was an indicator of active liver inflammation.
其他文献
CT(computed tomography)为计算机断层成像,是现代医学重要的影像学检查诊断技术之一.三维口腔锥束CT能够得到与实际结构一致的三维高分辨率解剖图像,有助于医生定性定量的分析口腔部位的形态结构、病变组织等.本文基于口腔CT图像,研究了全景图自动合成与牙根管中心轴自动提取两个方面的内容:(1)本文首先根据牙弓线,得到连续的牙齿矢状面剖切图,然后在连续牙齿矢状面剖切图上提取全景图拟合曲
The significant distribution of {411 } texture exists during the preparation of thin-gauge grain-oriented silicon steels, which has effect on the abnormal growth of Goss grains during the secondary r
The duplex stainless steels after solid solution at different temperature were subjected to the same cold rolling and annealing for varied time at 1323 K.The interfacial boundary character distributio
为获取足够多数量的真实晶粒样本,对纯铁晶粒组织进行了大尺度的三维重建.重建实验方法采用系列截面法,分析范围为1.3mm×1.8mm×0.54mm,实验获取了二维系列截面300张.针对大尺度情况下三维重建工作量急剧增加等问题,对晶界提取与封闭、晶粒分割等图像处理过程进行了优化.采用计算机与人工相结合的方法在保证重建精度的情况下大大提高了重建效率,在可接受的时间范围内完成了大尺度纯铁晶粒组织的三维重建
2205双相不锈钢在一定温度下时效处理会产生析出相,冷轧变形处理会影响析出相析出,进而影响其耐蚀性能.文本研究了热轧与冷轧2205双相不锈钢析出相与腐蚀规律的联系.利用光学显微镜(OM)和扫描电子显微镜(SEM)配合能谱仪(EDS)观察了析出相显微组织的变化,利用X射线衍射仪(XRD)对冷轧变形过程中可能出现的应变诱发马氏体及析出相进行分析.结果表明,在850℃时效会依次析出x相和σ相,经冷轧变形
利用相变法可在低牌号电工钢中制备出强{100}织构晶粒,从而有效地提高磁性能.将5mm厚的实验钢热轧板冷轧至0.2mm厚,然后分别在不同的热处理工艺下进行相变退火.利用电子背散射衍射(EBSD)技术获得热处理后样品的取向数据图.结果表明,在4L/minH2较低流量下,较低温度(1000℃)退火后的板材中形成了两个半厚的柱状晶组织,主要为{110}织构;而在8L/minH2较高流量下,较低温度退火后
The 0.30 mm grain-oriented silicon steel was scribed by laser equipment.The effect of parameters such as laser power, laser frequency, scanning speed and scribing spacing on the domain width were inve
在应力疲劳加载条件下,实验温度为800℃时,15CrMoNbTi铁素体不锈钢的疲劳极限为35MPa,当引入10s的保持时间后,15CrMoNbTi铁素体不锈钢的寿命大幅度降低.两种不同加载条件下的疲劳裂纹均以穿晶方式萌生于试样表面且以穿晶方式进行扩展.保持时间为0s时,在15CrMoNbTi铁素体不锈钢疲劳变形区可观察到大量的高密度位错缠结,在局部区域还存在网状位错结构.引入10s的保持时间后,在
目的:用镁作为造孔剂,制备出多孔材料,研究羟基磷灰石烧结行为以及镁在羟基磷灰石中的存在形式,探索研究烧结温度及造孔剂(锓)含量对组织结构的影响.方法:本文采用化学沉淀法,用Ca(H2PO4)·H2O和Ca(OH)2为原料制备纳米HA粉体,将n-HA粉体和Mg粉按一定比例混合后,在200MPa的压力下压制成型,经高温烧结(1100～1300℃)制备多孔含Mg羟基磷灰石(Mg-HA),利用XRD、SE
Background Non-alcoholic steatoheaptitis (NASH) , the critical stage of non-alcoholic fatty liver disease (NAFLD) , is of chronic progression and can develop cirrhosis even hepatocellular carcinoma (H