【摘 要】
：
The frame compliance is calibrated by experimental and calculation methods for an instrumented equipment.The indentation depth and diameter with single cycle test is determined by confocal laser scann
【机 构】
：
State Grid Liaoning Electric Power Research Institute,Shenyang,P.R.China
【出 处】
：
第四届微试样测试技术国际学术会议((The 4th International Conference on Small
论文部分内容阅读
The frame compliance is calibrated by experimental and calculation methods for an instrumented equipment.The indentation depth and diameter with single cycle test is determined by confocal laser scanning microscopy directly.
其他文献
In service components such as steam pipes,pipe branches,gas and steam turbine blades,etc.which operate in engineering applications such as power plant,aero-engines,chemical plant etc.,can operate at t
This paper describes the development of fatigue testing machine for small sized test specimens in liquid conditions.This type of fatigue testing machine is not available commercially so the testing ma
The symmetrical bending fatigue behavior of micron scale copper bonding wires with different diameter was examined by using a new device for microcantilevers based on self-excited vibration principle.
Solder alloys are widely used as connecting materials in electronic devices.Currently,lead free solders are used for soldering because of RoHS directive that restricted the use of certain hazardous su
Small specimen is widely used in mechanical test of reactor structural materials due to the limited volume in irradiation facility and less activity after irradiated.
For strain-controlled fatigue tests,especially at elevated temperature,implementation of knife-edges and punching dimples within gauge length of specimen may cause premature failure on the test sectio
Toevaluate the strength reliability of the electronic substrate,it is requiredto obtain the creep properties of the solder joint in-situ.The indentation test is one of effective method to evaluate the
In this work,a novel method for determining the creep damage properties which can be used to represent the full life until failure from a miniature bending creep test specimen is developed based on a
Although nowadays the Instrumented Indentation Test(IIT)can be applied to the fields from nano-micro-to macroscopic scale,this paper only addresses its application in the area of life assessment of co
Fatigue property of materials is an important input while estimating the residual life of critical components,as,fatigue data(stress vs.cycles or strain vs.cycles or fatigue crack growth rate data)are