【摘 要】
：
Membrane-based total heat exchanger is a device to recover both sensible heat and moisture from exhaust air stream from a building.Heat and mass transfer intensification was performed by using a struc
【机 构】
：
Key Laboratory of Enhanced Heat Transfer and Energy Conservation of Education Ministry, School of Ch
【出 处】
：
2nd International Workshop on Heat Transfer Advances for Ene
论文部分内容阅读
Membrane-based total heat exchanger is a device to recover both sensible heat and moisture from exhaust air stream from a building.Heat and mass transfer intensification was performed by using a structure of cross-corrugated triangular ducts.In this study, a test rig was built to measure the performance of the total heat exchanger.For comparison, two cores, one in cross-corrugated triangular ducts and another in parallel flat plates, were constructed and tested.
其他文献
Generally, passive perforated tiles are used in a data center and the supplied air flow rate is under-provisioned thus the balance server air requirement is met by the hot air in the room resulting in
In thermoelectric based power generation, the primary research focus has typically involved the properties of the material used in the thermoelectric material.While improving the material properties c
Presently, a significant portion of our energy is still derived from the oil and gas (ONG) industry.Until a cheaper alternate and/or near complete depletion of ONG resources, it will remain our major
The low temperature lift heat pump (LTLHP) utilizes a small difference between the condensing and evaporating temperatures of a working fluid.It requires a larger heat transfer area, a higher volume f
Inclination influences the flow patterns and thus the heat transfer during condensation in smooth tubes.However, not a lot of work has been done on diabatic two-phase flows in inclined tubes which in
The issue about the unprecedented demand for energy has become more and more serious nowadays due to the population growth and booming industry development.The environment stresses mainly from global
Solid oxide fuel cells (SOFCs) allow conversion of a wide range of fuels, including various hydrocarbon fuels.The relatively high operating temperature allows for highly efficient conversion to power,
The dynamic droplet behaviors, such as coalescence, departure, and out-of-plane jumping, can lead to great effect on the dropwise condensation (DWC) heat transfer.This paper briefly introduces this to
Presented are data which illustrate the effects of Mach number, Reynolds number, temperature ratio, and hole spacing on surface Nusselt numbers produced by an array of jets impinging on a flat plate.T
Fins and fin arrays, which are used to enhance heat transfer, should be small in weight and volume, and the fans, which create flow, should consume little energy.Furthermore, to prevent failure, compo