【摘 要】
：
The assembly effect of automotive exterior parts directly affects the automobile modelling design, and the gap and flush of automotive exterior parts is essential to evaluate assembly effect of auto e
【机 构】
：
Changan Auto Global R&D Center,Changan Automobile Co.,Ltd.
论文部分内容阅读
The assembly effect of automotive exterior parts directly affects the automobile modelling design, and the gap and flush of automotive exterior parts is essential to evaluate assembly effect of auto exterior parts.In the assembly relation of the machine, the assembly dimensional chain consists of relevant parts size or mutual position relation.The gap and flush of automotive exterior parts can be considered as a closing link of assembly dimensional chain, while the size and position relation of parts do influence the gap and flush,that should be understood as component link of assembly link.According to the basic principle of the mathematical statistics, the assembly dimensional chain should be calculated by statistical tolerance formula.In the four parameters, there are four different optimizing methods of tolerance allocation when three of them are stable.The analysis of assembly dimensional chain of automotive exterior parts should not be adopted into earlier designing stage, but also into later producing stage.
其他文献
Based on road load data of commercial trucks cab suspension system, extreme value and standard deviation of acceleration signals are statistically analyzed.And then pseudo-damage analysis is done to g
Driving style may affect fuel economy and driving ability, therefore, its evaluation becomes an important research topic for vehicle calibration and control.In this work, we propose to evaluate the dr
A performance test method of lane departure warning system(LDWS) with Prescan software is proposed.In the process of virtual integration, the LDWS camera is located in the front of a computer monitor
Two development trends (integrated and distributed) of the vehicle electronic and electrical architecture as well as their advantage and disadvantage are analyzed.Based on the detail research to the d
During the engine starting process, the speed always gets up and back to idle speed slowly, in order to solve these problems, at the same time to control the combustion during the starting process mor
Commercial vehicles will have to meet increasing requirements in the future with regard to further reductions in emissions and fuel consumption.A holistic view of the subjects thermodynamics/after-tre
A computer vision based system is proposed to detect four types of commonly used parking slots for Intelligent Parking Assistance System.It consists of two sub-modules, i.e.around view construction an
Combustion engines emissions of vehicles under real drive condition require special attention.Since the implementation of Euro 4 technology for commercial vehicles in 2005, the SCR technology has been
This paper aims to solve the problem that under the economic situation, how to deal with the energy-saving objection and profit for enterprises dealing with passenger vehicle.The research in this pape
The improvement of formability by pulsating hydroforming process of 6016 aluminium alloy tubular part of one car is examined using finite element simulation.The effects of the amplitude and cycle numb