【摘 要】
：
In through-process simulations of.aluminium sheet production, several physical models are needed to simulate all relevant hardening and softening mechanisms during rolling and annealing.By coupling th
【机 构】
：
Institut für Metallkunde und Metallphysik, Germany
【出 处】
：
15th International Conference on Aluminium Alloys(ICAA15)(第十
论文部分内容阅读
In through-process simulations of.aluminium sheet production, several physical models are needed to simulate all relevant hardening and softening mechanisms during rolling and annealing.By coupling these models throughout the process and using the processing parameters, mechanical properties like the yield stress and plastic anisotropy can be predicted.
其他文献
The steering support is the important part because it is high demand for safety, vibration and noise reduction, and as the connection and supporting the dashboard, various electrical appliances and in
The influence of modes on heat treatment of ingots and semi-finished products from alloys A1-Mg-Sc and Al-Cu-Li systems on the structure, phase composition and grain structure was studied.The EBSD dat
The microstructure evolution during the homogenization heat treatment of Al-Mg-Si-Fe-Mn, or AA6xxx, alloys has been investigated using a combination of modelling and experimental studies.The model is
One of the main goals in this work has been to maintain initial material strength, while keeping the added solute level to a minimum.It was found that replacing some Mg and Si with Li in a lean Al 606
In this study, the microstructural evolution of an as-cast AA3105 aluminium alloy during homogenization treatment was simulated with the ClaNG model.The simulated data were compared with experimental
Although several investigations on thermodynamic modelling in Al-Mg alloys were carried out, all previous thermodynamic descriptions have not been able to calculate the metastable phase diagrams of or
T4 process of cold rolled strip in the floater-type furnace has high heat transfer efficiency.In order to study the rapid characteristic, heat transfer equation of strip in floater-type furnace is est
Powder deposition is the main direct energy deposition (DED) additive manufacturing technique.To date, the bulk of the work was carried out on Ti, SS and Superalloys.With respect to Al alloys, the lit
Aluminium profiles show very often an anisotropic deformation behaviour and inhomogeneous properties over cross section especially of thick-wall profiles.The damage behaviour of aluminium profiles dep
The stacking fault energies (SFEs) of various aluminum solid solutions were investigated against temperature and solute concentration using first-principles energy calculations.Three types of impuriti