【摘 要】
：
Transmission shafts are the key parts in the deployable mechanism of antenna of satellite.They are long and thin, and endure the load of torture.The shafts
【机 构】
：
Aerospace System Engineering Shanghai,Shanghai 201108,China
【出 处】
：
第二届中国国际复合材料科技大会 (CCCM-2)
论文部分内容阅读
Transmission shafts are the key parts in the deployable mechanism of antenna of satellite.They are long and thin, and endure the load of torture.The shafts must be very light.Steels were used to be used, but the mass is too large.Because of the merits of the composites,such as low density, high ratios of strength/ density and stiffness/ density, good fatigue durability, low thermal dilation and integration, they are suitable to be the material for the Transmission Shafts of satellite.This paper describes the research of material and process design to make the shafts.
其他文献
将智能材料黏贴在叶片表面或嵌入叶片内部形成新的结构,智能材料作为传感器和作动器,通过机电耦合抑制叶片的振动.在压电陶瓷第一压电方程的基础上,把风电叶片简化成柔性
分段式风电叶片是解决长叶片运输和制造困难的有效方案，本文综述了分段式风电叶片相关的基础研究和技术发展概况，分析了大型复合材料分段式叶片的连接构造特点和技术优势，展
以理论计算为基础，制备了熔化与凝固相变温度分别为19.93℃和16.84℃的CA-PA-SA三元低共熔混合物.以CA-PA-SA为相变材料，活性炭(AC)为基体材料，利用物理共混法制备出了可应
风电叶片是复合材料应用的大型结构典范。风电行业发展至今，风电机组的度电成本要求越来越低，风火同价的呼声要求越来越高，风电叶片的成本也受到了业主和主机厂密切关注。本
从实验及数值模拟两个方面研究梯度波纹缺陷对复合材料层合板刚度影响。采用VARI成型工艺制作复合材料梯度波纹板试样，通过压缩测试测得其杨氏模量和泊松比，并观察试样的失
The Yutu (Jade Rabbit) moon rover of China landed the moon on December 14,2013.All instruments of rover are installed on its structure, which fulfills the d
以棕榈蜡CW为相变蓄热材料，膨胀石墨EG为添加剂，利用膨胀石墨多孔吸附及高导热特性，配比出最佳质量比为10∶1的棕榈蜡/膨胀石墨复合相变蓄热材料CW/EG.采用差示扫描量热仪(D
选用癸酸,月桂酸,肉豆蔻酸,软脂酸和硬脂酸及其二元低共熔物作为相变材料,在span20/SDS的乳化作用下,高速剪切制备了相变乳液.通过差示扫描量热仪对制备的相变乳液的热物
Drilling carbon fiber reinforced plastics (CFRP) products with high efficiency and quality is primary condition for applicating in aerospace industry.Diamon
A theoretical analysis based on shear-lag theory was carried out to analysis the load distribution under the thrust load in lap region between skirt and cas