The research on velocities of fragments from internal explosion in reinforced concrete

来源 :第十届全国冲击动力学讨论会 | 被引量 : 0次 | 上传用户:sarahfung
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
  The movement of concrete fragment from internal explosion in reinforced concrete is analyzed, and a model is built for the description of fragments acceleration. Make use of stress wave theory and EOS of detonation product, the velocity of fragment could be determined, with the interaction between steel and concrete and their deformation harmony considered. The computational results are compared with experimental ones with an analysis for the error.
其他文献
  The dynamic behavior of simple supported rectangular thin plate subjected to transverse harmonic excitation is investigated in this paper. The compressive l
  To protect movable cultural relics,by shaking table tests oscillation responses of museum free-standing cultural relics under earthquakes were studied.Based
  In this paper, a model for cracks in the mainshaft of nuclear reactor coolant circulation pumps is established. Symplectic technique is used to derive the a
  A bio-shock tube with non-lethal pressure levels can be used to study blast-induced primary injuries. In this paper, a finite element shock tube model was d
  By means of ping-gong balls, the dynamic buckling behaviours of thin-walled spherical shells under impact loading are studied both experimentally and nume
  本文将一种尺寸的SPS复合钢板分别根据不同的使用目的,采用三种等效计算方法换算为不同厚度的纯钢板,并分别对复合钢板和纯钢板进行平头弹侵彻仿真分析。等效计算方法分别
  In this paper, two loosely coupled single degree of freedom (SDOF) systems are used to generate pressure-impulse diagrams(P-I) with the flexural and direct
  The fragmentation of rock induced by impact loading is one of typical nonlinear problems in underground engineering rock specimen such as rock plate was fou
  Reactive powder concrete(RPC) is an new kind of high-performance cement based material. In order to systematically study dynamic mechanics character of reac
  Quasistatic compressive strength of alumina cylinders was measured using specimen of two sizes. The strength of the material was dependent on the specimen s