Heat transfer on a ribbed U-bend surface relevant for the blade-tip cooling

来源 :2nd International Workshop on Heat Transfer Advances for Ene | 被引量 : 0次 | 上传用户:hahabiaoren
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
  Tip-wall heat transfer in a U-bend channel has been examined experimentally by using the liquid crystal technique.Periodic square ribs were fitted onto the tip surface to increase the turbulence level and enhance the heat transfer.The ribs block the channel by 6% of its hydraulic diameter.
其他文献
Non-intrusive measurements are highly desirable in the study of modern thermal-fluid systems.One of the key bottlenecks of studying such systems stems from the experimental difficulty to resolve the g
In this study, a program adopting classical heat transfer and pressure drop correlations to iterate the in-tube heat transfer and pressure drop of micro-channel condenser (MC)on tube pass after anothe
Gas temperature distribution of combustion systems is an important factor for the practical combustors such as engines and gas turbines.Temperature which is one of the important combustion parameters
A small-scale organic Rankine cycle system has been established for converting low-enthalpy heat to power.In this experimental prototype, refrigerant HFC-245fa was used as the working fluid.A scroll e
Liquid suction heat exchangers are commonly installed in refrigeration system with the intent of ensuring proper system operation and increasing system performance.Previous researchers have investigat
The heat transfer performance of a mist/air jet impingement on a constant heat flux surface was experimentally investigated.Two objectives were outlined in the current study.The first objective is aim
Results on experimental investigation of heat transfer, crisis phenomena and wave characteristics in the liquid films falling over the vertical tubes with different surface shape are presented.The mix
Jet impingement has been investigated widely owing to its high rates of convective heat transfer near the stagnation zone.Nanofluids, beyond the traditional working fluids, have great advantages in hi
In this study, the adiabatic film cooling effectiveness and conjugate heat transfer characteristics for a circular hole were investigated numerically.Seven turbulator ribs were located on the internal
The aim of this work is experimental investigation of heat transfer and crisis phenomena development at boiling in falling liquid film subcooled at the inlet or fed at the line of saturation at stepwi