The impact of Magnesium and Zinc ions on the hydration kinetics of C3S

来源 :The 14th International Congress on the Chemistry of Cement ( | 被引量 : 0次 | 上传用户:persistence2005
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
  The alite phase in Portland cement contains different foreign ions.In this work, the effects of magnesium and zinc on the polymorph, hydration kinetics and hydrate morphology of C3S are investigated.It is found that the presence of the two ions has distinct effects on the hydration kinetics.Zinc increases the maximum heat released.Magnesium increases the hydration peak width.The C-S-H morphology is impacted by the presence of these ions.Longer needles are observed in the presence of zinc and thicker needles are observed in the presence of magnesium.Zinc is incorporated in C-S-H, while magnesium is only incorporated slightly, if at all, but rather seems to inhibit nucleation.
其他文献
Tricalcium silicate is the main component of cement, and the key phase during OPC hydration.Therefore, a detailed control over its reactivity could entail important technological and economical advanc
Belite-rich cements with enhanced reactivity have been long pursued, due to the benefits of the low sintering temperature and CaCO3 demand compared with alite-rich cements.In this work, the physi-and
In the manufacture of ordinary Portland cement, the clinker is inter-ground with mineral gypsum which provides sulphate ions to regulate hydration of calcium aluminate (C3A) phase resulting in retarda
Hydration of slag-cement cementitious material was studied through the use of a mode TAM Air eight-channel isothermal conductive calorimeter that measured the hydration heat emission rate and quantity
Rapid water-loss is one of the important characters on thin layer mortar.The testing methods, such as the velocity of water migration, the strength of interfacial bonding, XRD, SEM, FTIR and TD-DSC-DT
In order to investigate the influence of temperature of low heat Portland cement on the performance of concrete mixed with polycaboxylate superplasticizer, this paper selected two kinds of polycaboxyl
The properties of cementitious materials are related to the microstructure of their binder matrix, which forms by a sequence of dissolution-precipitation reactions converting the clinker phases into h
Heat Curing may lead to high early strength for concrete but weakened mechanical and durability performance at later stage because of its poor microstructure formed by the rapid precipitation of hydra
The electrical resistivity and the self-deformation were measured for the cement pastes with a fixed water to binder ratio of 0.4 and different expansive agent replacements of cement (0%, 6%, 10%, and
This study has the purpose to investigate the action of Magnesium Chloride (MgC12), which is present in the rocks of the salterns pre-salt layers, when it is incorporated to the Portland cement of G c