• 不 限
  • 期刊论文
  • 硕博论文
  • 会议论文
  • 报 纸
  • 英文论文
  2. 您的位置
  3. 首页
  4. 会议论文
  5. Thermal and mechanical design of HTS quadrupole magnet for pre-separator of in-flight fragment syste

Thermal and mechanical design of HTS quadrupole magnet for pre-separator of in-flight fragment syste

来源 :第八届亚洲应用超导会议 | 被引量 : 0次 | 上传用户：jiaomengni
【摘 要】
：
　　IF(In-flight Fragment) system is used to produce and analysis an isotope beam,a pre-separator is located in the front end of this system.The pre-separator r
【作 者】
：
HeecheolPark[1]SeokhoKim[1]KideokSim[2]HyunchulJo[3]DoGyunKim[3]JongwonKim[3] 
【机 构】
：
Changwon National University,Changwon,641-773,Korea
【出 处】
：
第八届亚洲应用超导会议
【发表日期】
：
2015年期
下载到本地 , 更方便阅读
下载此文 赞助VIP
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
　　IF(In-flight Fragment) system is used to produce and analysis an isotope beam,a pre-separator is located in the front end of this system.The pre-separator requires high magnetic field gradient to focus ion beam and,superconducting magnet can be a solution of that.Lorentz force by high magnetic field generates mechanical large stress in the magnet and structural design is important issue to reduce the stress concentration.
其他文献
Thermal Design and Analysis of HTS Section for a Vapor-Cooled HTS-Copper 5-kA Current Lead
　　Among many types of current leads used for Tokamak nuclear fusion applications,vapor-cooled current leads are often chosen because of their reliability and
会议
Active Inductance Compensation for the Quench Detection of the KSTAR CS Coil
　　Tokamak is a fusion reactor which has been world-widely researched for the future energy generation.Superconducting magnet system is a key component to make
会议
Characteristics of the Magnetic Flux-Offset Type FCL by Switching Component
　　The study of superconducting fault current limiter (SFCL) is continuously being studied as a countermeasure for reducing fault-current in the power system.W
会议
An effective cryostat design of conduction-cooled HTS magnets for a 300 kW-class HTS DC induction fu
　　A superconducting magnet is operated under cryogenic conditions.To effectively design a cryostat with high temperature superconducting (HTS) magnets,heat in
会议
Design and results of the Gas-liquid two-phase Cooled YBCO Magnet System for a 500 kW HTS Generator
　　With the wind turbine generator proposes higher individual capacity and greater power density,the HTS generator shows a wide application prospect in the fut
会议
Design and Fabrication of HTS windings for the 1250kVA Three-Phase Transformer
　　The design of high temperature superconducting (HTS) windings for the 1250kVA/10.5/0.4kV three-phase transformer using BSCCO is presented.The numerical anal
会议
Detection Method of Local Normal-State Transition in No-Insulation REBCO Pancake Coil
　　It is well known that a premature quench,often initiated by mechanical disturbances in a low temperature superconducting (LTS) coil,is extremely rare in a h
会议
Analysis of the Wireless power transmission efficiency using the superconductor antenna modeling
　　In this study,The wireless power transmission(WPT) characteristics were analyzed by the magnetic resonance transmitter and receiver antenna modeling.To impr
会议
A Conceptual Structure Design for a Conventional Section of a Nuclear Fusion Device's Vapor-Coo
　　A vapor-cooled HTS current lead of TOKAMAK for nuclear fusion devices basically consists of two sections.First,an upper section of current lead generally is
会议
Applications simulation of large scale high temperature superconducting energy storage systems in Zh
　　The intermittency and unexpectedness of renewable energy and more interconnections within grids pose substantial threats such as power imbalance,voltage sag
会议