Effect of Solution Treatment on Structure and Mechanical Properties of Fe-Mn-Al-Si Light Steel After

来源 :2016中国汽车工程学会年会 | 被引量 : 0次 | 上传用户:LEADERGYF
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
  The solution treatment of three different components of Fe-Mn-Al-Si light steel after cold rolling are carried out at 1050℃ and the time is 1h,30min,10min.The microstructure and mechanical properties of steel is investigated by using optical microscopy,drawing machine,XRD and SEM.Results shows that with the increasing of heat treatment time,the tensile strength of No.1 and No.2 reduces and the elongation of No.1 and No.2 firstly increases after an initial decrease; the tensile strength and elongation of No.3 decreases with the heat treatment time increasing.The microstructure of three different components of steels are always austenite + ferrite and the content of retained austenite increases with the heat treatment time increasing.There is no phase transformation and Transformation Induced Plasticity occurs during the deformation of the tested steel.
其他文献
By means of High speed camera and CCD camera,combining with high energy laser device,spray characteristics test of multi-hole injector for gasoline direct injection engine have been done on the consta
This paper aimed at the problem of casting defects during the trial manufacture of a certain engine cylinder head.Combined with the structural characteristics of the internal integrated exhaust manifo
Spray characteristics of Ethanol-Fatty Acid Methyl Ester Blends under common-rail injection condition were experimental investigated,by the high speed photography and particle/droplet image analyses(P
采用一种改进型的串联式离子电流检测系统,在一台1.3L四缸增压汽油机上开展了离子电流信号的典型特性,尤其是爆燃工况下特性的试验研究.结果表明:该检测系统离子电流的频率特性可较好地判定中强爆燃工况,但在轻微爆燃工况有一定的局限;离子电流积分值能进一步提高爆燃工况判定的准确率,达到87.2%.针对爆燃强度的识别,离子电流峰值和平均幅值与爆燃强度有很强的正相关性,采用加权平均的数学方法能优化离子电流爆燃
对一台增压中冷高压共轨的柴油发动机,燃用煤基费托合成柴油(F-T柴油)时的燃烧、排放特性和微粒粒度分布特征进行试验研究,分析了F-T柴油对发动机燃烧和排放的影响规律.结果表明,与国V柴油相比,燃用F-T柴油时因密度低,在喷油策略不做改变的情况下,转矩有所降低.同时,由于F-T柴油主要成分为直链烷烃,燃料着火性好,十六烷值较高,滞燃期明显缩短,预混合燃烧阶段放热量减少,燃烧时缸内温度降低,有利于降低
An experimental investigation of multiple injection at intake stroke under warm up conditions was performed in a GDI engine.With a constant excess air ratio,the effects of multiple injection strategy
This paper has developeda start-stop control system on a GDI engine,studied effectson the rate of ignition for expansion cylinder and the start-stop performance without a starter.The experimental resu
When it comes to GDI start-stop technology,the control of final stop crank angle can never be neglected.The probabilitydistribution of this final angle could be obtained via repetitious engine stop ex
Vehicle-to-vehicle communications bring new opportunities to ADAS,as it allows the vehicles to acquire more information of the environment and extends the range of perception.However,V2V communication
Based on the classical laminate theory,the stacking structure and its joining structure of a carbon fiber composite drive shaft are designed with the carbon fiber epoxy resin as the substrate.The stat