【摘 要】
：
This paper analyzes precipitation and dislocation strengthening behaviors of a 27mm thick Niobium-bearing Grade X80 steel plate for strain based design line pipe manufacture.The steel is produced by t
【机 构】
：
Shandong Iron and Steel Co.,LtdNo. 4 Building,2000 Shunhua Road,Jinan 250101 P. R.China
论文部分内容阅读
This paper analyzes precipitation and dislocation strengthening behaviors of a 27mm thick Niobium-bearing Grade X80 steel plate for strain based design line pipe manufacture.The steel is produced by thermal-mechanical processing(TMCP)and is characterized with granular bainite and polygonal ferrite microstructure.Mechanical properties of both the steel and the UOE pipe are briefly introduced.Transmission electron microscope(TEM)is used to investigate the fine grain structure,distribution of the precipitates and dislocations in the steel.Precipitate morphologies,volume fractions of M(C,N),M3C,CaS,AlN and Cu are extensively studied respectively by Electrolytic Chemical Phase Analysis(ECPA)and X-ray Small Angle Diffraction(X-ray SAD).Dislocations in the steel are characterized with Positron Annihilation analysis.The results prove that precipitation hardening reveal a 58.1MPa strengthening contribution by the precipitates less than 20nm in size.Dislocation hardening is approximately 176MPa to the present studied steel and 198MPa to the pipe.
其他文献
According to the technical specifications of 700MPa high strength automotive axle tube steel,a low cost of 0.07%C+1.5%Mn+0.05%Nb+0.10%Ti was designed.The high strength mainly relies on grain refinemen
Effect of rare earth element Ce on behavior of high temperature deformation of IF steel was discussed.Different Ce content in IF steel were heated to 1250℃ for 5 min with a heating rate of 10/s at vac
In the study a low carbon niobium bearing high strength F-B dual phase automobile steel with high hole expansion property has been investigated.Steels of different chemical composition have been inves
Handan Iron and Steel production of high-strength structural car steel QStE500TM thin gauge products using Nb + Ti composite strengthening,with a small amount of Cr element to improve its hardenabilit
This paper reports on the experience with the production of 27/33 mm X80 heavy wall thicknesses,large OD(48”)in Shouqin Steel Co.,Ltd.(SQS).Considering the technology capability of the plate mill in S
Hydrocarbon pipelines transporting compressible products like methane or high-vapor-pressure(HVP)liquids under supercritical conditions can be susceptible to long-propagating failures.As the unplanned
With the increase of wall thickness of pipeline steel,DWTT fracture toughness has become more and more sensitive to production process,including alloy design and processing,so it need more tight and m
Repeated deformation with optimum reductions in roughing mill exceeds the critical amount of strain required for recrystallization to occur.Recrystallization during roughing mill rolling refines auste
Over the past twenty years,significant advances have been made in the field of microalloying and associated application,among which one of the most successful application cases is HTP practice for hea
The susceptibility to hydrogen embrittlement in high strength mooring chain steel with different boron content(0,0.003%,0.008%)were investigated by electrochemical hydrogen charging technique and tens