【摘 要】
：
The boundary conditions leading to pitting in pipelines in the water/hydrocarbon (HC) interface region of the bottom-of-the-line (BOL) liquid were studied using electrochemical noise (ECN) with specia
【机 构】
：
IFINKOR-Institute for Maintenance and Corrosion Protection Technologies n.f.p.Ltd.Kalkofen 4,D-58638
【出 处】
：
2013中国国际管道会议暨第一届中国管道与储罐腐蚀与防护学术交流会
论文部分内容阅读
The boundary conditions leading to pitting in pipelines in the water/hydrocarbon (HC) interface region of the bottom-of-the-line (BOL) liquid were studied using electrochemical noise (ECN) with specially developed evaluation software.It was proved that intermittent surface wetting with HC and brine can increase the likelihood of pitting in the HC/brine boundary region of the pipeline steel.The frequency of the phase boundary movement affects the pitting intensity.Corrosive effects were strongly dependent on the presence of inhibitors, its concentration and phase behaviour influenced by isopropanol.Increasing the inhibitor concentration mitigates pit formation in all surface regions.ECN measurements in combination with the in-house developed evaluation software proved to be a sensitive tool to quantify parameter effects in short exposure times.
其他文献
利用科氏流量计弯曲振动的特性,系统分析了测量管内黏性流体随测量管弯曲振动产生的黏性力及其耗能规律,推导出测量管道谐振时流体粘度与能耗之间的数学模型.通过轴向无流速和有流速实验,验证了基于弯曲振动流体粘度测量技术的可行性;最后对实验测量中的影响因素进行了分析.该技术对采用科氏流量计进行粘度测量研究具有一定的指导意义.
随着北京市经济的快速发展及对油品市场的巨大需求,为保证北京市的油品供应,中国石油拟在北京市建设输油管道.因沿线经济发达、限制条件多,如按常规设计思路新建一条输油管道工程难度大、投资高.考虑节约用地、保护环境、节省投资、统一管理等多方面因素,输油管道全线与正在建设的陕京三线并行敷设.依据中国石油《油气管道并行敷设技术规范》并结合并行管道在设计、施工、运营方面的要求,经对输油管道与陕京三线并行敷设的技
To arrive at an optimal liquid pipeline design, a pipeline should not only be designed for the lowest overall life cycle capital (CAPEX) and operating (OPEX) costs, but also bedesigned to cost effecti
This study was initiated to understand the role of minor cyclic loading, a typical scenario of pressure fluctuations during the operation of high-pressure gas transmission pipelines, in overall crack
Poly a-olefin as drag reduce agent (DRA) with more than 6 million molecular weight would lost most of drag reducing rate after shearing degradation.Commonly, adding DRA was adapted after shearing degr
In this work, a new, finite element analysis-based model, the CX model, was developed to investigate the effect of corrosion defect, internal pressure and soil-induced strain on the local stress distr
Carbon and low alloy steel notionally sweet pipelines could be in danger of sudden and/or severe cracking and, consequently, loss of containment if H2S is introduced into the media, even for a short t
油气站场的工艺管道是站场的重要组成部分,其安全运行是站场正常工作的前提.由于站场上的工艺管道与干线管道的风险比较类似,因此工艺管道的完整性管理可以借鉴部分干线完整性管理的做法.完整性管理以风险为核心、以检测为主要手段,最终通过维修维护来削减风险.站场工艺管道的风险以腐蚀为主,在开展检测前,采用定量方法对腐蚀泄漏的风险进行定量评价,然后针对性地制订检测计划.目前针对工艺管道,已经有比较成熟的检测技术
Congested existing buried piping or pipeline networks "within" or "close to" old plant facilities such as, gathering centers, booster stations, pipeline manifolds, etc.are normally electrically contin
In this work, a real-time AC/DC (altemating current/direct current) signal data acquisition (DAQ) technique was developed, which enabled separation of AC and DC components from the recorded total volt