Time delay compensation in lateral-directional flight control systems at high angles of attack

来源 :中国航空学报(英文版) | 被引量 : 0次 | 上传用户:sfish001
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
The previous studies of time delay compensation in flight control systems are all based on the conventional aerodynamic derivative model and conducted in longitudinal motions at low angles of attack.In this investigation,the effects of time delay on the lateral-directional stability augmentation system in high-α regime are discussed based on theβ model,which is proposed in our previous work and proved as a more accurate aerodynamic model to reveal the lateraldirectional unsteady aerodynamic characteristics at high angles of attack.Both theβ model and the quasi-steady model are used for simulating the effects of time delay on the flying qualities in high-α maneuvers.The comparison between the simulation results shows that the flying qualities are much more sensitive to the mismatch of feedback gains than the state errors caused by time delay.Then a typical adaptive controller based on the conventional dynamic derivative model and a gain-prediction compensator based onβ model are designed to address the time delay in different maneuvers.The simulation results show that the gain-prediction compensator is much simpler and more efficient at high angles of attack.Finally,the gain-prediction compensator is combined with a linearized βmodel reference adaptive controller to compensate the adverse effects of very large time delay,which exhibits excellent performance when addressing the extreme conditions at high angles of attack.
其他文献
To efficiently compute arbitrary propellant grain evolution of the burning surface with uniform and non-uniform burning rate for solid rocket motor,a unified fr
Single-pass honing is an important machining method for finish machining of holes,which can meet the requirement for high efficiency and consistency of holes.Ch
In the 3D free bending forming system,the bending die can be designed either in a sliding type or rolling friction type.Bending die-based sliding friction type
Via material erosion in wire electrical discharge machining (WEDM),recast layers form on the surfaces of workpiece.In addition,ultra fine Wire-EDM can be usuall
Accurate engine performance models are important for model-based performance evaluation of aero engine.The accuracy of the model often depends on engine compone
An accurate estimation of tool wear morphology can provide the opportunity to investigate the influence of tool wear on cutting performance as well as reduce th
A probability-based damage tolerance methodology has been proposed to improve the recognition of material anomalies,especially hard alpha (TiN) anomalies for ae
This paper addresses the challenge of synchronized multiple spacecraft attitude reorientation in presence of pointing and boundary constraints with limited inte
Vibrations in aircraft hydraulic pipeline system,due to multi-source excitation of high fluid pressure fluctuation and serious vibration environment of airframe
Obtaining accurate development cost estimation results of general aviation aircraft is crucial for companies to adopt the best strategy in the development proce