论文部分内容阅读
部标准《飞机电机电器环境试验方法》已经正式批准,于1976年九月一日开始实施。标准编号为HB6—71—76。本标准是以1966年的原《飞机电机电器总兹术条件》草案稿为基础,在总结工厂,研究所和部队多年来在生产,科研和使用中所积累的经验的基础上,通过多次调查研究和必要的验证试验,反复的讨论修改,并参阅了国内外有关的技术资料而制订出来的。制订本标准的主要目的是为了实现飞机电机电器产品环境试验方法的标准化,改变过去在环境试验方法上的混乱,陈旧和落后状况,以满足我国航空工业迅速发展的需要。
Ministry of Standards “Aircraft electrical and mechanical environment test method” has been officially approved in September 1, 1976 began. Standard number is HB6-71-76. This standard is based on the original 1966 draft “General Conditions of Aircraft Electrical and Mechanical Equipment,” draft, based on the summary of experience accumulated in the production, research and use of factories, research institutes and units over the years, Investigation and the necessary verification test, repeated discussion and revision, and refer to the relevant technical information at home and abroad to develop. The main purpose of this standard is to standardize the environmental test methods of aircraft electrical products and change the confusion, outdated and backward conditions in the environmental test methods in the past in order to meet the rapid development of China's aviation industry.