我队修配所在没有铣床设备的情况下,为了铣削加工活塞刮油涨圈的进油槽,设计制造了一套在车床上铣削的工具,经实践证明,效果很好.工具加工情况,如图1所示.铣刀安置在铣桿上面,铣桿一端夹在车床床头上,另一端用尾顶针顶住.涨圈是用二块压板(见图2)夹住,然后利用二个长方头螺钉(见图3)从压板的两个孔中穿过,放 My team is equipped with no milling machine equipment where the case, in order to milling piston ring up the oil into the groove, the design and manufacture of a set of tools in the lathe milling, proven by practice, the effect is good. Tool processing, as shown in Figure 1 Shown in Figure 1. Milling cutter placed above the milling rod, one end of the milling rod sandwiched on the bed and the other end of the top of the needle with a tail.Take up the ring with two platen (see Figure 2), and then use two rectangular Head screws (see Figure 3) pass through the two holes in the platen and place