【摘 要】
：
Stray light analysis of a three-mirror spatial optical system is presented. The entrance pupil diameter (EPD) of the system is 320 mm, the e?ective focal length (EFL) is 2809 mm, and the field of view (FOV) is 1°×0.5°. Its walls are coated with extinction
【机 构】
：
SchoolofOptoelectronics,BeijingInstituteofTechnology,Beijing100081,China
【出 处】
：
ChineseOpticsLetters
论文部分内容阅读
Stray light analysis of a three-mirror spatial optical system is presented. The entrance pupil diameter (EPD) of the system is 320 mm, the e?ective focal length (EFL) is 2809 mm, and the field of view (FOV) is 1°×0.5°. Its walls are coated with extinction paint (the absorption coeffcient of which is 97%). The point source transmittance (PST) of the system is thus reduced by up to two orders of magnitude. Moreover, this technique makes it feasible to block the stray light coming from outside of the FOV by increasing the outer baffle length of the system. Adding an inner baffle to both the primary and the secondary mirrors helps not only to block the stray light coming from outside of the FOV but also to decrease the length of the outer baffle. Simulation results show that the PST values are less than 10
其他文献
采用光刻离子交换法制作六角形孔径的高填充率梯度折射率(GRIN)平面微透镜阵列可有六角形和圆形两种开孔方式。通过设计两种孔径的六角形排列模板，采用光刻离子交换法并分时段取样，分别对形成高填充率GRIN平面微透镜阵列的两种开孔方式的离子扩散特性进行测试和分析，得到了这两种开孔方式在r方向和z方向的离子扩散和开孔表面凸起的特性，为制作不同孔径大小与开孔间距的高填充率GRIN平面微透镜阵列提供了工艺和理论参考。
本文介绍了一种新型电子学装置,它可以使小功率He-Ne激光器输出功率稳定度达到0.5%,在声频范围的噪声与通常稳流电源相比,可降低20 dB.
Mathematical models for the superimposed orbital angular momentum (OAM) mode of multiple Hankel–Bessel (HB) beams in anisotropic non-Kolmogorov turbulence are developed. The effects of anisotropic turbulence and source parameters on the mode detection spe
基于科斯塔斯(COSTAS)光学锁相环路载波恢复进行建模分析,得到系统的闭环传递函数、误差函数及需要恢复的载波信号;设计系统采用复合控制,内环借助声光移频器实现快速、小范围跟踪,外环通过环路直接控制激光器拉进快捕带;为了得到良好的载波恢复和信号解调,设计基于异或门的COSTAS环鉴相模块对鉴相器进行分析,实现鉴相范围为[-42°,42°],鉴相增益为14.4 mV/(°) ,在环路带宽为1.5 MHz时,搭建实验进行测试。实验结果表明在码速率5 Gb/s时,载波恢复、信号解调良好,信号光功率为-40.4
本文在载流子扩散方程的基础上,用龙格一库塔、辛普生等数值分析法,对“新月”形隐埋波导耦合集成型激光器进行了动态特性分析。分析了器件结构参数的影响。探索降低阈值电流的途径。文内还指出了进一步提高器件质量和改进的方向。
本文在论证了用空间信息量表示成像光学系统总体性能的基础上,提出了信息量的计算公式F=K(J~2/λ~2)·(S~2/S_0~2)或F=K(J~2/λ~2)·(M~2/M_0~2)或F=K(J~2/λ~2)·(P~2/P_0~2),阐述了它的物理意义,并给出了计算实例.
A compact directional backlight module of time-multiplexed auto-stereoscopic display based on side-glowing polymer optical fiber (SGPOF) is proposed. The optical system is mainly composed of SGPOF array and cylindrical lens array. Spatial crosstalk is red
本文提出了一种适用于TMA CO_2激光器的谐振腔,采用方孔耦合输出。它的输出光斑均匀,发散角比一般平凹腔改善4倍。
以TiCl4为前驱体, 采用溶胶-凝胶法(sol-gel)制备了0.1%～3.0%(摩尔分数)Er3 掺杂纳米TiO2晶体。X射线衍射(XRD)、透射电镜(TEM)、傅里叶红外光谱仪(FTIR)和拉曼光谱(Raman)分析了Er3 掺杂TiO2晶体的结构、组成和声子能量。TiO2纳米晶体颗粒大小随着Er3 掺杂浓度的增加而减小。在980 nm激发下, 样品发出很强的来自于Er3 的2H11/2→4I15/2, 4S3/2→4I15/2(绿光)和4F9/2→4I15/2(红光)跃迁的上转换发光。研究了上转换