Using Geogrid-Reinforced Soil(GRS)we studied the working mechanism and design method of GRS at bridge approach with high backfill by field experiment.In a highway section where the height of backfill is 13.5 meters,geogrids were used at two bridge approaches to address the bumping problems.Some soil pressure cells were used to measure the normal and lateral soil pressure at different locations in the roadbed. The experimental results indicate that geogrids in geogrid-reinforced soil(GRS)could produce an uplift force,the closer the location to the abutment,the larger the uplift force,and the reduction of measured soil pressures compared with theoretical values was the largest at the bottom of roadbed,less at the top than at the bottom,and the least in the mid-height of roadbed than at the bottom.These findings are different from those of the traditional greogrid-reinforced subgrade design method. Using Geogrid-Reinforced Soil (GRS) we studied the working mechanism and design method of GRS at bridge approach with high backfill by field experiment. In a highway section where the height of back fill is 13.5 meters, geogrids were used at two bridge approaches to address the bumping problems.Some soil pressure cells were used to measure the normal and lateral soil pressure at different locations in the roadbed. The experimental results that geogrids in geogrid-reinforced soil (GRS) could produce an uplift force, the closer the location to the abutment, the larger the uplift force, and the reduction of measured soil pressures than with the theoretical values ​​was the largest at the bottom of roadbed, less at the top than at the bottom, and the least in the mid-height of the roadbed than at the bottom. These findings are different from those of the traditional greogrid-reinforced subgrade design method.