论文部分内容阅读
Preparation and Characterization of Mullite-Silicon Carbide Heat Absorbing Ceramics for Solar Therma
【机 构】
：
School of Material Science and Engineering, Wuhan University of Technology, Wuhan 430070, China
【出 处】
：
武汉理工大学学报（材料科学版）（英文版）
【发表日期】
：
2015年1期
其他文献
Hot compression tests on AZ40 magnesium alloy were conducted on a Gleeble 1500d hot simulation testing machine in a deformation temperature range of 330 ℃-420 ℃ and a strain rate range of 0.002-2 s-1. Hot deformation behaviors were investigated on the bas
A reconstruction method is proposed for the polyurethane foam and then a complete numerical method is developed to predict the effective thermal conductivity of the polyurethane foam.The finite volume method is applied to solve the 2D heterogeneous pure c
Microstructure and Mechanical Performance of Cu-SnO2-rGO based Composites Prepared by Plasma Activat
A novel chemical technique combined with unique plasma activated sintering (PAS) was utilized to prepare consolidated copper matrix composites (CMCs) by adding Cu-SnO2-rGO layered micro powders as reinforced fillers into Cu matrix. The repeating Cu-SnO2-r
An accelerated laboratory method (saturated ammonium nitrate solution immersion method) was used to analyze the degradation of cement decalcification process. By studying the changes of intensity, volume, elastic modulus, quality, pH value, the Ca/Si, and
A Low Cost and Facile Preparation of Hydrophobic Silica Films and Powders by a Solution-based Proces
Super-hydrophobic surfaces with water contact angle (WCA) higher than 150° generated a lot of interests both in academic and in industry because of their self-cleaning functionality. Emphasis was given to the effect of pH value on the hydrophobic behavior
The effect of carbonation on fatigue performance of ground granulated blast-furnace slag concrete was investigated. Based on the static compression tests of carbonated GGBS-concrete, the correlation between carbonation depth and compressive strength was a
A new corona protection varnish was prepared by using epoxy/montmorillonite nano-composite and pure epoxy resin as adhesives respectively. The adhesive with different amounts of organic montmorillonite (OMMT) was mixed with 1200 mesh silicon carbide (SiC)
The pyrolysis behavior of polycarbosilane (PCS) and chemical reaction mechanism during the pyrolysis process were studied by thermogravimetric-mass spectrometry (TG-MS) combined with X-ray diffraction and infrared spectroscopic analysis methods. The exper