【摘 要】
：
The sinter cooling flue gas expelled from the end of an annular cooler was taken as the heat source of an organic Rankine cycle(ORC)system,and R123,R245fa,R600,
【机 构】
：
School of Environment and Energy Engineering,Anhui Jianzhu University,Hefei 230026,Anhui,China“,”Sch
论文部分内容阅读
The sinter cooling flue gas expelled from the end of an annular cooler was taken as the heat source of an organic Rankine cycle(ORC)system,and R123,R245fa,R600,R601 and R601a were selected as the working fluids of the ORC system.The effects of evaporation temperature and superheat degree of working fluid,as well as the pinch point temperature difference in the evaporator on the system thermal performance,were analyzed in detail.The results show that the system net output power and exergy efficiency for different working fluids first increase and then decrease with an increase in the evaporation temperature and decrease with an increase in the superheat degree and pinch point temperature difference.The change in pinch point temperature difference has no effect on the system thermal efficiency.For a given operational condition,the system thermal efficiency and exergy efficiency of R123 are the maximum,while the system total irreversible loss of R245fa is the maximum.When the evaporation temperature is greater than 110 ℃,the system net output power of R600 is the maximum.The ORC system could obtain the maximum net output power and exergy efficiency through the adjustment of evaporation temperature of working fluid.
其他文献
Variations in tensile behavior and properties after pre-strain and thermal aging were differently affected by strain aging phenomenon dependent on microstructur
[目的]果园生草在促进树体生长发育、改善土壤理化环境和土壤肥力等方面起着重要作用,本研究旨在解决我国果园普遍存在的立地条件差和土壤改良困难、有机质含量少且缺乏补充
The crystallization behavior of blast-face slag under isothermal and continuous-cooling conditions was studied using the single hot thermocouple technique.The c
[目的]研究小麦、玉米专用硫磺树脂包膜尿素(SRCU)在水中和土壤中的氮素释放规律及其与作物氮素吸收的匹配性,并研究现有条件下其与普通尿素的配施比例,为调整该产品的氮素释
In order to increase the reaction rates between the molten steel and the slag and cut down the reduction time when the top slag of manganese ore is added into t
Warm deformation behavior of the Fe-6.5wt.％Si alloy was studied by isothermal compression in the temperature range of 300-700℃.The results show that the influen
The retained austenite content in TRIP590 steel was first measured by X-ray diffraction(XRD)method.Then,the effect of different test parameters(indexing rate,st
Recovering iron and aluminum efficiently is the key route to utilize low-grade high-iron bauxite.Aiming to optimize the iron separating process and elevate both
Low-carbon steel is widely used for household appliance and automotive panel steel because of its excellent plasticity.Unfortunately,yield point phenomena easil
Microstructure evolution or degradation has been well recognized to be closely related to the formation of microcracks in pearlitic rails and wheels.The rolling