【摘 要】
：
Supersonic flows with high Mach number are ubiquitous in astrophysics. High-powered lasers also have the ability to drive high Mach number, radiating shock waves in laboratory plasmas, and recent experiments along these lines have made it possible to recr
【机 构】
：
RiceUniversity,USAUniversityofMichigan-AnnArbor,USALawrenceLivermoreNationalLaboratory,USAAwePlc,UK
【出 处】
：
HighPowerLaserScienceandEngineering
论文部分内容阅读
Supersonic flows with high Mach number are ubiquitous in astrophysics. High-powered lasers also have the ability to drive high Mach number, radiating shock waves in laboratory plasmas, and recent experiments along these lines have made it possible to recreate analogs of high Mach-number astrophysical flows under controlled conditions. Streak cameras such as the Rochester optical streak system (ROSS) are particularly helpful in diagnosing such experiments, because they acquire spatially resolved measurements of the radiating gas continuously over a large time interval, making it easy to observe how any shock waves and ablation fronts present in the system evolve with time. This paper summarizes new ROSS observations of a laboratory analog of the collision of a stellar wind with an ablating planetary atmosphere embedded within a magnetosphere. We find good agreement between the observed ROSS data and numerical models obtained with the FLASH code, but only when the effects of optical depth are properly taken into account.
其他文献
Pure zinc blende structure GaAs/AlGaAs axial heterostructure nanowires (NWs) are grown by metal organic chemical vapor deposition on GaAs(111) B substrates using Au-catalyzed vapor-liquid-solid mechanism. Al adatom enhances the influence of diameters on N
采用同轴送粉激光熔覆技术在Ti811表面制备了CeO2质量分数分别为0,1%,3%的TC4 Ni45 CeO2多道搭接激光熔覆层。采用X射线衍射仪、扫描电镜和能谱仪分析了熔覆层的微观组织和物相,利用显微硬度计、摩擦磨损试验机和白光轮廓仪测试分析了熔覆层的显微硬度和摩擦磨损性能。结果表明:熔覆层中的物相包括TiC、TiB2、TiB、Ti2Ni和α-Ti;随着CeO2加入量增加,熔覆层中的物相未发生改变;当CeO2添加量为0时,熔覆层内部组织粗大,显微硬度为590~640 HV,磨损机制主要为磨粒磨损和黏着磨
美帝阿符科公司已研制成一种理论上可产生几百万瓦红外光的气体动力激光器。1965年首次创制成的这种气体动力激光器不同于一般的气体激光器，它是通过燃烧燃料（如一氧化碳或氰）来提供CO2-N2混合气体的，而一般激光器是通过放电获得能量。
测量了Cr:Nd:GSGG晶体从-70 ℃到 80 ℃温度下的荧光发射光谱和荧光寿命,计算了该晶体在不同温度下1.061 μm受激发射截面,获得在此温度变化范围内受激发射截面随温度的线性变化关系。
为适应包括变系数方程在内的非线性发展方程求解的需要，试图探求辅助方程的多样化和解的形式的更为一般化，对王明亮提出的(G′/G)- 展开法进行了更有意义的推广。为验证此推广的有效性，将它应用到常系数变形Boussinesq方程组II 中，取得了多组精确行波解。 实践证明此推广具有很好的适用性。
为研究激光选区熔化(SLM)工艺成形CX马氏体时效不锈钢时的成形质量与力学性能,基于单熔道实验确定了CX马氏体时效不锈钢SLM成形的工艺窗口。在此基础上,分析了离焦量对SLM成形CX马氏体时效不锈钢试样致密度、硬度和表面粗糙度的影响规律。结合拉伸实验和微观组织观察,研究了热处理前后试样力学性能的变化规律。结果表明:在低离焦量时,激光能量密度过高,熔池不稳定性增加,球化现象明显,试样致密度和硬度降低,表面粗糙度升高,拉伸断口呈准解理断裂特征;随离焦量增大,适宜的能量密度和光斑尺寸有利于相邻熔道间和层间形成良
The approximative formula for the far-field diffraction of a Gaussian beam through a circular aperture is obtained by using the superposition of Gaussian beams instead of the aperture function, and the explicit expression for calculating the beam divergen
In this paper, we demonstrate a scheme to tailor both longitudinal and transverse modes inside a laser cavity and constitute an eye-safe single longitudinal mode
相对论大电流电子束（REB)作为一种能在短时间内集中获得大能量的新的束源，正在引起极大的注意。1934年Bennet曾对以电子束自身聚束为中心进行过探讨，而后Alfven(1939)在与宇宙射线传播有关的问题上得出了有限传输的Alfven电流，所以说，在理论上，很早以前对REB就进行了研究。但是，尽管如此，实际上直到1960年才研制出这样的电子束，从此，这一领域的研究工作才得到飞跃的发展。REB技术是英国的AWEE (原子武器研究中心)首次研究成功，之后以美国和苏联为中心开展了大规模的研究，如今能够得到每