论文部分内容阅读
普通蓄电池在启用之前,极板表面会有一定程度的氧化、存放的时间越长,氧化越严重,加入电解液后,会出现急剧升温现象,在充电时会产生较大的电阻,使充电困难。因此,启用新蓄电池应做到:加注电解液后,应静放6小时左右,待电解液完全浸透极板,温度下降至35℃以下,再接通电源进行充电,充电电流要严格控制在规定以内。如果在充电过程中,升温过高,超过45℃时,可减少电流或暂停充电,进行1—2次充、放电循环,使其达到额定容量
Ordinary batteries in the opening before the plate surface will be a certain degree of oxidation, the longer storage time, the more serious oxidation, after adding electrolyte, there will be a sharp heating phenomenon, the charging will have a greater resistance, so difficult to charge . Therefore, to enable a new battery should do: After filling electrolyte, should be allowed to rest for about 6 hours until the electrolyte completely saturated plate, the temperature dropped below 35 ℃, then turn on the power to charge, the charge current should be strictly controlled at Within the provisions. If the charging process, the temperature is too high, more than 45 ℃, you can reduce the current or suspend the charge, 1-2 charge and discharge cycles, so that it reaches the rated capacity