【摘 要】
：
A novel heat substrate technique,high frequency inductive heat deposition(IHD),was introduced to coat porous carbon materials,C/C and carbon felt to improve the
【机 构】
：
Shenzhen Key Laboratory of Special Functional Materials
【出 处】
：
武汉理工大学学报（材料科学版）（英文版）
论文部分内容阅读
A novel heat substrate technique,high frequency inductive heat deposition(IHD),was introduced to coat porous carbon materials,C/C and carbon felt to improve their bioactivity.The morphologies,composition and microstructure of the resulting coatings were examined by scanning electron microscopy(SEM),energy dispersive spectra(EDS),X-ray diffractometer(XRD)and Fourier transform infrared spectroscopy (FTIR).The results show that,the calcium phosphate consisted of non-stoichiometric,CO3-containing and plate-like octacalcium phosphate(Ca8-xH2(PO4)6,OCP)could uniformly cover the entire porous surfaces of carbon materials.Good adhesion of the coating to carbon material substrates was observed.
其他文献
We present a brief review about recent results regarding carbon nanotube (CNT)-based chemical and biomolecular sensors. For the fabrication of CNT-based sensors
Nanocrystalline Gd1.77 Yb0.2Er0.03O3 samples were prepared by combustion and precipitation methods.Structures and upconversion luminescence properties of sample
YbCl3-MCl (M = Na, K, Rb, Cs) systems were optimized and calculated using the CALPHAD (CALculation of PHAse Diagram) technique. The modified quasi-chemical mode
The preparation of Al(OH)3 by the ion exchange membrane electrolysis followed by the precipitation of sodium aluminate solution with seeds was made. During the
随着现代生态环境遭到严重破坏的现状，如何更好的对现有生态环境加以保护，如何降低因经济发展而对生态环境造成的损害，如何提高人为生态工程的发展等都已经成为全世界人们所关注
Accurate solid concentration measurement plays a keY role in the process industry.Measurements analvzed offline can be used to estimate process efficiencies,to
目的对按照《中国药典》2010年版方法标定的氢氧化钠滴定液浓度进行不确定度评定。方法通过不确定来源分析,建立滴定液不确定度的数学模型,对标定过程中各种影响因素进行分析
采用混凝沉淀工艺对城市二级出水回用于火电厂循环冷却水系统进行深度处理,仅对浊度和CODCr有较好的去除,但出水中有机物和氨氮仍未达到火电厂循环冷却水系统的要求.为此,考
The properties of the passivation film formed on 316L stainless steel were studied by Electrochemical Impedance Spectroscopy(EIS),Mott-Schottky and Voltammetry
Tensile tests of solid solution treated 7050 aluminum alloy were conducted to different strain degrees (0.1, 0.4, 0.6 and failure) at 460 ℃ with the strain rat