刀具锥柄通常为莫氏锥体,插入锥套后有相当楔紧力,如果锥套后部没有可以施力的孔,拆卸是很困难的。可如图所示,用两块楔铁夹在刀柄和锥套的轴肩之间,可用台虎钳挤压楔块,也可用小锤轻敲楔块,使两斜面相对平移,产生轴向力,就可使两者分离。根据常 Tool taper shank usually Morse, after inserting the taper sleeve has a considerable wedge tightness, if the taper sleeve can not force the rear of the hole, the removal is very difficult. As shown in the figure, two wedges are clamped between the shoulder of the shank and the taper sleeve. The vise can be pressed by a vise. The wedge can also be tapped by a small hammer to make the two bevels move relative to each other to produce a shaft To force, you can make the two separate. According to often