论文部分内容阅读
(1)后大轴使用一年左右,弯曲度小于0.4毫米,可将后大轴调头换边使用。这样,既节约了材料,又延长了后大轴的使用寿命。 (2)最终传动主、被动齿轮(包括驱动鼓)可以换边使用。这是因为,拖拉机作业时前进档用得多,后退档用得少,故齿轮轮齿磨得一边多一边少,换边使用后,可延长主、被动齿轮的使用寿命。 (3)最终传动减速壳可以换边使用。拖拉机作业时,有的托链板被履带板刮坏以致螺孔磨损,换边使用后,下边的孔又可装托链板。 (4)转向离合器总成可以左、右互换使用,这样
(1) After about a year after the big axis, the curvature of less than 0.4 mm, the rear axle can be used to change the head. In this way, both material savings, but also extend the life of the big shaft. (2) The final drive main, driven gear (including the drive drum) can be changed edge use. This is because, when tractor operation, the forward gear is much more and the reverse gear is used less, so the gear wheel gear is worn on one side and the other side is less. After using the gear, the service life of the primary and the passive gear can be prolonged. (3) the final drive deceleration shell can be changed for use. Tractor operation, some of the chain board is scratched by the track shoe so that the screw hole wear, change the edge of use, the lower hole can hold the chain board. (4) steering clutch assembly can be left and right interchangeable use, so