【摘 要】
：
A novel optical burst switching (OBS) high speed network architecture has been proposed. To verify its feasibility and evaluate its performance, just-enough-time (JET) signaling has been considered as a high performance protocol. In the proposed architect
【机 构】
：
SchoolofElectronicsandCommunicationEngineering,ShriMataVaishnoDeviUniversity(JandK),India2Department
【出 处】
：
ChineseOpticsLetters
论文部分内容阅读
A novel optical burst switching (OBS) high speed network architecture has been proposed. To verify its feasibility and evaluate its performance, just-enough-time (JET) signaling has been considered as a high performance protocol. In the proposed architecture, to avoid burst losses, firstly, a short-prior-confirmation-packet (SPCP) is sent over the control channel that simulates the events that the actual packet will experience. Once SPCP detects a drop at any of the intermediate nodes, the actual packet is not sent but the process repeats. In order to increase network utilization, cost effectiveness and to overcome some limitations of conventional OBS, inherent codes (e.g., orthogonal optical codes (OOC)), which are codified only in intensity, has been used. Through simulations, it shows that a decrease in burst loss probability, cost effectiveness and a gain in processing time are obtained when optical label processing is used as compared with electronic processing.
其他文献
High-quality AlN/sapphire templates were fabricated by the combination of sputtering and high-temperature (HT) annealing. The influence of sputtering parameters including nitrogen flux, radio frequency power, and substrate temperature on the crystalline q
提出了一种软X射线荧光吸收谱测试方法。该方法克服了软X射线荧光产率低的问题,消除了荧光自吸收效应,采用部分荧光产额模式获得了材料的软X射线近边吸收结构。使用部分荧光产额模式对钙钛矿太阳能电池的埋藏元素、催化剂的低浓度元素,以及宽禁带半导体进行软X射线近边吸收谱研究。相比全电子产额模式,基于荧光产额模式的软X射线近边吸收结构在材料体相特性、不良导体和低浓度样品测试中更具优势。
目前发展的激光器其阈值电流低于1 mA，可不需偏压和稳压而直接用逻辑电平信号驱动。半导体激光器将为在兆赫时标率上工作的未来超级电子计算机系统中起重要作用。电子计算机结构中的增加并行性对互连机构提出了严格要求。在这方面，光学互接器件比对应的电子器件具有相当大的优点。然而，对于电子计箅机光学互连的应用，通用半导体激光器不能适用。
在三维数字散斑整像素相关搜索中,先利用极线约束和投影校正原理将相关搜索范围从整个图像约束到投影校正后的同一水平极线上,再利用视差约束缩小搜索范围,该相关搜索过程非常耗时。在投影校正和视差约束的基础上,提出了基于灰度约束的三维数字散斑整像素相关搜索方法,该方法可进一步滤除视差范围内大部分的待匹配点。当有效点个数为85783、相关窗口大小为9pixel×9pixel时,相关搜索时间由7.24s缩短为2
本文报道在硅酸盐钕玻璃激光器中消除激光自锁模现象及实现单纵模运转的方法,并给出实验结果。
传统的视频拼接模型和图像对齐方法中,耗时的图像匹配和复杂的光流计算一直是实时拼接的性能瓶颈。提出了一种车载前向运动视频的实时全景成像方法,该方法充分利用物理场景的几何结构和列车的运动信息来构造视频的拼接区域,并建立几何模型实现了拼接区域的对齐。整个拼接避免了复杂的图像处理过程,实现了铁路全景图的实时获取,同时也提供了一种轻量级的视频全景索引方式,降低了视频数据的存储和访问开销。
Solid-state atomic-sized color centers in wide-band-gap semiconductors, such as diamond, silicon carbide, and hexagonal boron nitride, are important platforms for quantum technologies, specifically for single-photon sources and quantum sensing. One of the
本文将编码位相片看作一种干涉滤色片进行了密度彩色化原理的理论分析和实验证明,并得出了一些有意义的结果。
基于自由空间法，设计研制了一套D波段透射率测试装置，对典型衣服、鞋底及快递包装进行了测试。该测试装置包括D波段矢量网络分析仪、高斯波束天线、双曲透镜、光学导轨以及固定夹具。采用直通反射-传输线（TRL）校准方法和时域门技术，提高了测试准确度，保证数据有效性。对10种厚薄不同的衣服进行了D波段透射率测试，测试曲线趋势与已报道文献结果吻合。对鞋底以及快递包装的透射率进行了测试，获得了与安保场景比较接近的数据，有利于安检系统的设计。