论文部分内容阅读
本文系张纬斌同志根据其研究生结业论文「造船厂—1与—8铝合金工件热处理方法的研究」缩写而成。科学指导人罗斯托夫蔡夫认为张同志「进行了追求最好热处理规程的大量研究工作,对于—1铝合金不仅在试样上而且在工件(活塞)上得到了良好结果」,并「进行了显微组织的研究,证明了所得的结论」,但对—8铝合金的研究「还需要进一步加以扩充和证实」。大连造船厂工程师苏联专家维斯尼雅可夫认为张同志的实际建议「已经为工厂的实践所证实,所推荐的个别工艺规程和工件及零件热处理规程可以采用」。国营某厂总工程师晋川认为张同志的研究工作对改进铝合金产品质量有一定程度的贡献。
This article is Comrade Zhang Weibin based on his graduate thesis “shipyard -1 and -8 aluminum alloy workpiece heat treatment method” acronym made. Science director Rostov-Chevov believed that Comrade Zhang “carried out a great deal of research in the pursuit of the best heat-treatment procedures, and” carried out the work on -1 aluminum alloy not only on the specimen but also on the work piece (piston) “ The study of microstructure proved the conclusion, ”but the research on -8 aluminum alloy“ needs to be further expanded and confirmed. ” Visayakov, a Soviet expert from Dalian Shipyard Engineer, believes that Comrade Zhang’s actual proposal “has been confirmed by the practice of the factory. The recommended individual process regulations and the heat treatment procedures for workpieces and parts can be adopted.” Jinchuan, chief engineer of a state-owned factory, believes that Zhang’s research has contributed to improving the quality of aluminum alloy products to a certain extent.